2. LowerSingle GST Rate Liability Earlier tax rate for taxpayers registered under the composition scheme: BusinessCGST+SGSTTotal Manufacturer and trader of goods0.5%+0.5%1% Non-Liquor Restaurants2.5%+2.5%5% Service Providers or mixed supplier of goods and services3%+3%6% ...
One person income from functional hall 16 lacs and other commerical rent income 6 lacs total 22 lacs received present year Gst new composite from 01 04 2019 rate of 6 percent scheme applicable or not
τ = RREC × Cµ highlights, and further confirms, that the high current obtained in the devices exploiting layered pho- toanode architectures is not only due to the reduction of recombination rate (indeed pure ZnO-based device presents the worst electron lifetime together with the highest re...
The surfactant optimization from 5 to 20 μL at CNTPGCPE for the detection of RF (0.1 mM) was performed using CV in 0.1 M PBS of pH 6.5 at a sweep rate of 0.1 V/s as shown in Fig. 2 (b). The elevated current is reached at 10 μL SLS because at 10 μL SLS the critical ...
The sulfur-rich copolymer exhibited a reduction in the active material dissolution into the electrolyte and a low self-discharge rate behavior during the rest time compared to an elemental sulfur cathode, indicating the chemical confinement of sulfur units. The presence of organosulfur moieties in ...
2. Related Work In this section, polarimetric and spatial feature sets are introduced, and the scheme of the construction of those two spaces is given. Then, the traditional method for fusing different feature is described. 2.1. Polarimetric and Spatial Features of PolSAR Image For PolSAR images...
The thermal imidzation process is as follows: heating from room temperature to 150 °C with a heat rate of 2 °C/min and holding at this temperature for 1 h, heating to 300 °C with a heat rate of 2.5 °C/min and holding at this temperature for 2 h, and then naturally cooling ...
qmax is the maximum adsorption capacity (mg/g), KL and KF are the adsorption rate constants of the Langmuir and Fre- undlich models, respectively, and n is the heterogeneity parameter [29]. Using linear regression, correlation coefficients (R2) were estimated and the adsorption isotherm models...
The fabrication of the composite separator was done by two main procedures following the scheme shown in Figure 1. First of all, the dilute suspension was applied onto both sides of the PE separators via a dip-coating process. The PTFE-coated separator was dried in a vacuum oven at 80 ...
A scheme of the vacuum bag for the liquid infusion is shown in Figure 1. With this procedure, the resin was forced to flow through the thickness of the preform using an external vacuum pump. After sealing, the vacuum bag was transferred into the autoclave for curing, pressure and ...