Development of Permanent Magnet MnAlC/Polymer Composites and Flexible Filament for Bonding and 3D-Printing Technologies. Sci. Technol. Adv. Mater. 2018, 19, 465–473. [Google Scholar] [CrossRef] Campos, H. What Is the Difference between TPE and TPU in 3D Printing? Available online: https:/...
(CFRP) has attracted many industries. However, on the other hand, the increasing demand for carbon fibers has created a waste recycling problem that must be overcome. In this context, increasing plastic waste from the new 3D printing technology has been increased, contributing to a greater need...
HereWurepresents the water uptake in percentage; whileWtis the weight of the sample at timetandWorepresent the weight of the sample before initiating the test. 3. Results and Discussion 3.1. Effects of Silane Treatment on Fibers The silane coupling agent increases the interfacial bonding between ...
Due to possible formation of hydrogen bonding, crack propagation at weak phase interfaces can be facilitated, resulting in a lower tensile strength of the blend, which is also reported in the literature [54]. Comparatively, one of the highest tensile strength values (15.66 MPa) was measured for...
Steel plate bonding and steel patching, which are CivilEng 2023, 4, 483–505. https://doi.org/10.3390/civileng4020028 https://www.mdpi.com/journal/civileng CivilEng 2023, 4 484 regarded as passive strengthening techniques, are just two of the techniques that have been developed for ...
In the other transition described as a weaker 𝑛−𝜋∗n−π*, transition occurs in the visible range at 465 nm, electrons absorb energy of 2.666 eV to move from nonbonding state to LUMO. The PMMA-BDK-MR thin films are initially exposed to UV-illumination for various time periods...