内容提示: 思科路由器防火墙配置命令(CISCO router firewall configuration command) 思科路由器防火墙配置命令(CISCO router firewall configuration command) Router firewall configuration command Reading text options: black red green blue yellow white grey blue background white pink grey green blue black blue ...
This module provides command line interface (CLI) commands for configuring Link Bundle interfaces on the Cisco 8000 Series Router. To use commands of this module, you must be in a user group associated with a task group that includes appropriate task IDs. If ...
11. User active print shows all the router OS active users. 12. System reboot and system shutdown are restart and shutdown respectively. System reset removes all the original configurations and restarts router os.14, the system resource monitor can monitor the current CPU and the usage of ...
Use the shutdown form of this command to shut down the specified feature card and drop all active calls. Cisco 10000 Series Router Usage Guidelines, In Cisco IOS Release 12.2(33)SB, when you enter the hw-module slot slot-number reset command, the software asks you to confirm the command....
A Cisco router has been configured with the following command:IP nat pool nat-test 192.168.6.10 192.168.6.20 netmask 255.255.255.0his is an example of what type of NAT?() Static NAT Dynamic NAT Dynamic NAT with overload Port Address Translation None of the above...
I am confused about the “no keepalive” and “no shutdown” command on different interface type on router. In serial interface, the status is down/down. But in ethernet interface, it is up/up. Could anyone please clear me? And can this reason apply with Catalyst too? Thank...
I have a network that is a branch of our central office. The central office is located in another city and I connect to the central office with a Cisco router using a leased line E1 cable(using Telco). When the telco line is down and I ping the branch office it gives me a ...
I am confused about the “no keepalive” and “no shutdown” command on different interface type on router. In serial interface, the status is down/down. But in ethernet interface, it is up/up. Could anyone please clear me? And can this reason apply with ...
Router(config)#interface fastEthernet 0/0输入接口“快速以太口0/0” 并进入。 Router(config-if)#此模式为接口配置模式 Router(config-if)#ip address 192.168.1.1 255.255.255.0输入接口IP地址和掩码 Router(config-if)#no shutdown路由器接口默认都为shutdown,所以要启用,就要打no shutdown ...
undebug all(turn off all debugging commands – handy if this is a busy router) Line editing commands ctrl-a(go to the beginning of the current line) ctrl-e(go to the end of the current line) ctrl-p or up-arrow(repeat up to 10 previous commands in the current mode) ...