When the device is used as a built-in Portal server, you can run theportal local-server ipcommand to configure an IP address for the built-in Portal server. Users are then redirected to the Portal server if they enter URLs that are not located in the free IP subnet. ...
Run the excluded-ip-address command to configure IP addresses in the IP address pool that cannot be automatically assigned. excluded-ip-address 172.20.0.2 172.20.0.254 The following error information is displayed: Error: Some of addresses not be excluded are not idle,or not in the pool. Alarm...
address Specifies the IP address of the destination device. address must be specified in IPv4 dotted decimal or IPv6 colon-separated-hexadecimal notation. Usage Guidelines Use this command to configure the IP address of the destination end of the tunnel. ...
The CLI command to configure an AnywhereUSB with a Static IP address is as follows: #> set network ip=x.x.x.x gateway=y.y.y.y submask=z.z.z.z dhcp=off static=on autoip=off Note: If needed, to re-enable the AnywhereUSB's DHCP client, either factory reset the AnywhereUSB or ...
This chapter describes the commands used to configure and monitor the Host Services and Applications on Cisco 8000 Series Routers. For detailed information about Host Services and Applications concepts, configuration tasks, and examples, refer to the IP Addresses and Services Co...
IP command is similar to ifconfig, which is very familiar for assigning Static IP Address, Route, Default Gateway, and configure network interface parameters on Linux system. IP command replaces the ifconfig command on modern Linux distributions because
Configure the /etc/named.conf file First, add or edit the two values in theoptionsfield. One is the DNS server address, and the other is theallow-querytoany. [root@servera ~]# vim /etc/named.conflisten-on port53{127.0.0.1;192.168.25.132;};allow-query{localhost;any;}; ...
We're going to use the netsh command, but it requires that Command Prompt be launched as administrator to work. Thenetshcommand allows you to configure just about any aspect of your network connections in Windows. To launch Command Prompt (or PowerShell) as Admin, open up the Start Menu, ...
You can configure the SQL Server services by using a built-in account, local account, or domain account. Note When you use a built-in account, you should not specify the corresponding password parameters. For more information about service account configuration, see Server Configuration - Service...
ip-address: IP address, in dotted decimal notation. mask: Subnet mask, in dotted decimal notation. mask-length: Subnet mask length, the number of consecutive ones in the mask. It is in the range of 0 to 32. sub: Specifies a secondary IP address of a VLAN or loopback interface. ...