Below is an overview of essential Windows CMD (Command Prompt) commands. Every command has a brief explanation and an example use case. 1. arp Command Thearp(Address Resolution Protocol) command shows and modifies entries in the ARP cache. Thecachecontains one or multiple tables that mapIP ad...
The undo dldp compatible-mode local-mac command restores the source MAC addresses of the DLDP packets to the default MAC address. By default, the MAC address of a DLDP packet is the system MAC address. Format dldp compatible-mode local-mac mac-address undo dldp compatible-mode local-mac [...
When a user logs in to the device, the user enters the user view and the following prompt is displayed on the screen: <HUAWEI> In the user view, you can view the running status and statistics of the device. System view Run the system-view command and press Enter in the user view....
-m | --modify Specifies that the following values be changed: 14 ESS 5.3.6: Command Reference • IP address • Host name • Subnet name • Domain name -r | --reboot Specifies an I/O node reboot after you modify the environment. -V | --version Specifies the version number and...
The FTP source address is the IP address of the interface used by the FTP packets to leave the networking device. Command Modes XR Config mode Command History Release Modification Release 7.0.12 This command was introduced. Usage Guidelines Use this command to set th...
By default, the ASA balances the packet load on interfaces according to the source and destination IP address (src-dst-ip ) of the packet. To change the algorithm, see the port-channel load-balance command. This command lets you view the current load-balancing algorithm, but, with t...
Click Start All Program Dell Command Configure Dell Command Configure Command Prompt. NOTE: If you are using a system running the Microsoft Windows 7 operating system or later, right-click Dell Command Configure Command Prompt, and select Run as administrator. 2. Run the Dell Command | Configure...
Presently, the device uses TFTP to implement backup operation. Example # Backup the main configuration file for next startup on the TFTP server with IP address 2.2..2.2, using the filename config.cfg. <Sysname> backup startup-configuration to 2.2.2.2 config.cfg Backup next startup-configuratio...
IPv4 address: 1.1.1.0 Message type: SNMP Trap Securityname: p1 Version: V1 IPv4 address: 1.1.1.1 Message type: Syslog Table 3 Command output Field Description IPv4 address IPv4 address of the poweroff alarm destination host. ...
To display the current status of EMM386 expanded-memory support, type emm386 at the command prompt:Parameterson|off|autoActivates the EMM386 device driver (if set to on), or suspends the EMM386 device driver (if set to off), or places the EMM386 device driver in auto mode (if set to...