If the file system is inconsistent, the mmfsck command displays information about the inconsistencies and, depending on the option that is entered, might prompt you for permission to repair them. The mmfsck command tries to avoid actions that might result in loss of data. However, in some cas...
Entering the above command sequence results in the following prompt: [context_name]host_name(crf-crypto-tmp1-ikev2-tunnel)# Syntax notify-payload { device-id | error-message-type { network-permanent | network-transient-major | network-transient-minor | ue }| p...
Executeexitto close the command line interface. One command at a time. This mode uses the Command Prompt and returns to the system prompt after the command is executed. To access this mode: Open Command Prompt (cmd.exe). Use thecdcommand to navigate to the installation folder ofBEST. Execu...
The prompt changes to switch(config-router-af)#: switch# configure terminal switch(config)# router isis 100 switch(config-router)# address-family ipv6 switch(config-router-af)# You must configure the address families if you are using route redistribution, address aggregation, loa...
At this point, records can be inserted into the airline_in table at any time with the following command (press ENTER at any time to get a scala> prompt):df.limit(10).write.format("com.kinetica.spark").options(options).save()Each time this command is given, a short loading sequence ...
免费在线预览全文 Dell戴尔DellEMCNetworkingCommandLineReferenceGuidefortheS5048F–ONSystem9.14.2.4说明书用户手册用户手册产品说明书使用说明文档安装使用手册 Dell EMC Networking Command Line Reference Guide for the S5048F–ON System November 2019 Rev. A00 Notes, cautions, and warnings NOTE: A NOTE indic...
If the file system is inconsistent, themmfsckcommand displays information about the inconsistencies and (depending on the option entered) may prompt you for permission to repair them. Themmfsckcommand tries to avoid actions that may result in loss of data. In some cases, however, it may indica...
Entering the above command sequence results in the following prompt: [context_name]host_name(crf-crypto-tmp1-ikev2-tunnel)# Syntax notify-payload { device-id | error-message-type { network-permanent | network-transient-major | network-transient-minor | ue }| pdn-t...
Entering the above command sequence results in the following prompt: [context_name]host_name(cfg-crypto-tmp1-ikev2-vendor)# Syntax configuration-payload private-attribute-type { imei integer | p-cscf-v4 v4_value | p-cscf-v6 v6_value } remove...
Exec > Global Configuration > Context Configuration > Crypto Template Configuration configure > context context_name > crypto template template_name ikev2-dynamic Entering the above command sequence results in the following prompt: [context_name]host_name(crf-c...