Reboot the system When someone approaches you for help with their computer, I suspect one of your first responses is, "Did you reboot it?" Restarting a computer helps with various problems and may even be necessary to finalize some configurations. However, restarting is considered downtime on a...
Learn Sign in Version PowerShell SDK 7.4 RemoveItemPropertyCommand RemoveJobCommand RemoveModuleCommand RemovePSBreakpointCommand RemovePSDriveCommand RemovePSSessionCommand RemoveServiceCommand RemoveTypeDataCommand RemoveVariableCommand RenameComputerChangeInfo ...
<servername> can be an IP address, a NetBIOS name, or a fully qualified domain name (FQDN).Windows Setup Exit CodesProširi tablicu Exit Code NameExit Code ValueDescription CONX_SETUP_EXITCODE_CONTINUE_REBOOT 0x3 This upgrade was successful. CONX_SETUP_EXITCODE_RESUME_AT_COMPAT_REPORT ...
Reboot the PC. Windows should appear. Set up or repair the boot menu on a dual-boot PC When setting up a PC to boot more than one operating system, you may sometimes lose the ability to boot into one of the operating systems. The BCDBoot option allows you to quickly add boot options...
Reboot the machine and enter the appropriate BIOS menus. If your boot devices are SCSI, refer to documentation on your SCSI controller on how to enter the SCSI BIOS. If the boot devices are maintained by the system BIOS, refer to system BIOS documentation on how to enter the system BIOS...
Reboot the PC. Windows should appear. Set up or repair the boot menu on a dual-boot PC When setting up a PC to boot more than one operating system, you may sometimes lose the ability to boot into one of the operating systems. The BCDBoot option allows you to quickly add boot options...
20 Using command line interface for Dell Command | Configure 4.2 3 Options for Dell Command | Configure 4.2 This chapter provides an overview of the Dell Command | Configure options. It describes the general and BIOS options to configure settings for the client systems. Dell Command | Configure...
If not set, set the BIOS password on the system. Type: cctk --setuppwd= 2. If not enabled, enable TPM. by typing the following command: cctk --tpm=on 3. Reboot the system. 4. To activate TPM, type the following command: cctk --tpmactivation=activate --valsetuppwd=...
AdpBootDrive {-Set -L[drive] | -physdrv[E0:S0]} | -Get -a[controller] Parameters -a[controller]: The RAID controller affected by the command -Set: Sets the virtual drive as bootable so that during the next reboot, the BIOS will look for a boot sector in the s...
The root device used by the kernel is specified in the boot configuration file on the kernel command line, as always.