Novel surfaces have been studied; although fouling rates are similar, evidence suggests that there may be improvements in cleaning as a result. More work is needed to understand the nature of the forces involved in binding food deposits to surfaces; this may lead to ways of minimizing or ...
Chadwick O, Nettleton WD (1990) Micromorphologic evidence of adhesive and cohesive forces in soil cementation. Soil Sci 19:207–212. doi: 10.1016/S0166-2481(08)70332-5Chadwick, F. and Nettleton, D. 1988. MiCromorphologic evidence of adhesive and cohesive forces in soil cementation. ...
5.1.3. Basic assumptions of FE vs. analytical models The FE and the analytical models compared in this section share the first two fundamental assumptions listed in Section 2.3, namely: (i) the shear and normal interfacial stresses are constant across the thickness of the adhesive layer; (ii)...
Todd P.SilversteinJournal of Chemical EducationSilverstein, T.P., 2004. Cohesive and adhesive forces versus surface tension gradients e revisited. J Chem Educ. 81, 35.
Cohesive and Adhesive Forces during CleaningChristian, GraceFryer, Peter
A problem which has arisen concurrently is the generalization of established representations of the effect of adhesive-cohesive forces of interaction on strength to the region of short times-to-failure (down to 10{sup {minus}6} sec or less) and, accordingly, high loading rates. These problems ...
Surface tension corresponds to the adhesive and cohesive forces resultant. Adding nanoparticles diminishes the cohesive force and simultaneously strengthens the adhesive force. Owing to the presence of MWCNTs, the effect of adhesion on the surface tension was superior to the effect of cohesion which ...
Surface tension corresponds to the adhesive and cohesive forces resultant. Adding nanoparticles diminishes the cohesive force and simultaneously strengthens the adhesive force. Owing to the presence of MWCNTs, the effect of adhesion on the surface tension was superior to the effect of cohesion which ...
However, when inter-particle adhesive forces are dominant, actual practices [11] show that the pressure drop balances Pwb at a theoretical level of 𝑈𝑚𝑓Umf, but that inter-particle forces prevent the particle bed from fluidization albeit the gas velocity is increased above 𝑈𝑚𝑓Umf....
According to Griffith’s fracture criterion, the debonding will take place when the work done by the applied load minus the energy stored in the system is larger than the work of the interfacial detachment, which is the adhesive fracture energy. This energy is the amount of energy to separate...