This can be used by the C-Bus Toolkit software when configuring a C-Bus installation. 4.0 Wiring Instructions The Pascal Automation Controller (PAC) may be mounted in a switchboard or external cabinet (such as a StarServe™ enclosure). Ensure to adequately segregate mains and extra low ...
The software does not do any programming of CBus and KNX; this must be done by the respective CBus Toolkit and KNX ETS tools. In the CBus to KNX mapping page, a CBus Application and group address is mapped to a KNX Group address of telegram type On/Off (1-bit), Relative Dimming (4...