Solid Blue: The power is on, the modem is working normally, and the firmware is not being updated. Blinking Blue: The firmware is being updated. Do not remove the modem from the PC. Blinking Amber: The modem is searching for service (initializing). Solid Amber: Error—either...
Blinking Amber: The modem has detected a 2G network (EDGE, GPRS, GSM) and is ready to connect. Solid Amber: The modem is connected to a 2G network and is able to send and receive data. 3G Off: The modem is unable to detect 3G service. Blinking Blue: The modem has detected ...
I have the same issue, after and before converting it to mobility express (ME) I cant see the SSID of cisco aironet 2800I, it is enabled and broadcast with BLUE,RED and GREEN blinking lights. I have reset it multiple times. 0 Helpful Reply Scott Fella Hall of Fame In ...
Then it will stop with the network being green, radio off and status is pink. 2) It will sit that way for a few minutes, then the cycle restarts with the ethernet blinking green, radio blinks red and status cycles colors. This time it ends with the ethernet off, radio red and status...
Blue Normal operating condition, at least one wireless client association Boot loader status Green Executing boot loader Boot loader error Blinking Green Boot loader signing verification failure Operating status Blinking Blue Software upgrade in progress ...
SYS LED - Blinking Amber and ALM LED = OFF. Condition : Console logging set to debugging and high rate of console logs are generated while you reboot the controller. Workaround : Do not set console logging to debugging and reboot the controller at the same time, or send the debug output...
WAP 2802 leds keep blinking by tm@solfabel.be 03-12-2018 in Routing • latest reply by Leo Laohoo 03-12-2018 03-12-2018 Hi, I connected the 2802 to the network yet the leds keep alternating green off blue off red off - means access point is being located - yet nothing else...
Symptom: Status LED on Cisco AP1552 in the local mode is blinking green when working in normal operation. Condition: Cisco AP1552 in the local mode. Workaround: Convert the Cisco AP to the mesh mode. OL-28977-01 Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points...