RJ-45 to RJ-45 rollover cable RJ-45 to DB-9 female DTE adapter (labeled “Terminal”) RJ-45 to DB-25 female DTE adapter (labeled “Terminal”) RJ-45 to DB-25 male DCE adapter (labeled “Modem”) Note Additional cables and adapters can be ordered from your customer servi...
–For RJ-45 connections, connect a 180 rollover cable from the M.A.S.H. adapter to a port on the terminal server. –For hydra cable assemblies, connect a straight-through patch cable from the M.A.S.H. adapter to a port on the terminal server. Step 2 Configure the line and port...
www.cisco.com ICND—3-2 Objectives(cont.)•Setupconsoleconnectionsbetweenrouters,switchesandaterminal•Documentthephysicaltopology,includingcabletypesandcablelocationsoneachinternetworkingdevice ©1999,CiscoSystems,Inc.www.cisco.com ICND—3-3 CablingtheCampus Legend FastEthernet/EthernetISDNDedicatedCore_...
try 115200 (Default Baud Rate) for sg300 that worked for me don't use blue rollover cable there unsupported The device also comes with default http access so you should be able to configure it over GUI if you cant get console working they come set as http://192.168.1.254 If your us...
This cable is used to connect a Cisco device's console port to a workstation in order to access the device's command-line configuration. This is occasionally referred to as a "rollover" cable, and Cisco-supplied cables are flat and light blue in color....
Pinout of APC Smart UPS cable Adapter pinoutShould work with APC UPSs that use the following cables: APC Part# 940-0024C, # 940-0024D or 940-1524(black cable) This is to plug a Cisco console (rollover) cable into.
You can use the RJ-45 rollover cable and RJ-45/DSUB F/F adapter (labeled “Terminal”) to connect the console port to a computer running terminal emulation software. Table 1-2 lists the pinouts for the console port, the RJ-45 rollover cable, and the RJ-45/DSUB F/F adapter....
Procedure Step 1 Step 2 Step 3 Step 4 Configure the console device to match these default port characteristics: • 9600 baud • 8 data bits • 1 stop bit • No parity Connect an RJ-45 rollover cable to the console port on the switch. F...
You can identify a rollover cable by comparing the two RJ-45 connectors at each end of the cable. When you hold the connectors side-by-side with the tab at the back, the wire connected to the pin on the outside of the left connector should be the same color as the pin on the ...
Use the supplied rollover cable and DB-9 adapter to connect a PC to the switch console port. You need to provide a RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a terminal. You can order a kit (part number ACS-DSBUASYN=) containing that...