Terminalserver(config)#interface loopback 1Terminalserver(config-if)#ip address 10.1.1.1 255.255.255.0 第二步:检查从终端服务器到终端设备的物理连接,并记下每台设备对应的行号。HWIC-8A提供8条线路,如输出所示。 Terminalserver#show lineTty Line Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns In...
RP/0/RP0/CPU0:router(config)# interface TenGigE 0/0/0/4 RP/0/RP0/CPU0:router(config-if)# loopback (Ethernet) To configure an Ethernet controller for loopback mode, use the loopback command in interface configuration mode. To disable loopback, use t...
Configure the interface as a Layer 2 trunk (required only if the interface is a Layer 2 access port or tunnel port or to specify the trunking mode). dynamic auto—Set the interface to a trunk link if the neighboring interface is set to trunk or desirable mode. This is the default. dyna...
Router(config)#interface type number Router(config)#interface type Slot/port 其中type是该接口的类型包括以下几种: serial广域网同步串口 ethernet以太网口 fastethernet快速以太网口 token ring令牌环口 fddi FDDI光口 hssi高速串口(45M) loopback本地虚接口 dialer拨号虚接口 null本地黑洞口 async异步口 atmATM...
Idk what is going on but I haven't really done much with this Controller since inheriting it a year ago, but all my SSID's are down and there are no AP's listed in the GUI.Where's a good starting point? Should I just factory reset this thing?Edit: I ... ...
interface GigabitEthernet0/2 ! end [0] Go to the IOS command prompt without saving this config. [1] Return back to the setup without saving this config. [2] Save this configuration to nvram and exit. Enter your selection [2]:
Encapsulation ARPA, loopback not set Full-duplex, 100Mb/s input flow-control is off, output flow-control is off ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:14, output 00:00:36, output hang never Last clearing of "show interface" counters never ...
Recovery command: "clear Disabled Timer interval: 300 seconds Interfaces that will be enabled at the next timeout: Interface Errdisable reason Time left(sec) --- --- --- Gi1/0/14 loopback 293 可以看到,所有的errdisable恢复类别都被激活,并且底部...
NativeIOS(config)#interface fastethernet3/2NativeIOS(config-if)#duplex fullDuplex will not be set until speed is set to non-auto value!--- Error: On this platform, you must set the speed before the duplex. !--- Not all switch platforms have this command ordering requirement.NativeIOS(con...
How do I configure the Cisco 4331 routers' ethernet-internal interface to communicate with a SM-X Layer 2/3 EtherSwitch Service Module? Neither interface ethernet-internal 1/0/0 nor interface ethernet-internal 1/0/1 have the ip address command available. They don't have the "no...