Layer 3 switch -L3 Layer 2 switches -SW-1en SW-2 L3 Switch>enSwitch#configure terminalEnter configuration commands, one per line. End with CNTL/Z. Switch(config)#hostname L3L3(config)#ip routingL3(config)#vtp mode serverDevice mode already VTP SERVER. L3(config)#vtp domain ci...
#interface FastEthernet 3/1#switchport access vlan13//设置接口绑定的 VLAN ID 为 13#exit 查看VLAN 信息 Switch#show vlan brief VLAN Name Status Ports--- --- --- ---1default active Fa4/1, Fa5/111VLAN0011 active Fa1/112VLAN0012 active Fa2/113VLAN0013 active Fa3/11002fddi-default active1...
(SVI) or Static Route Moving a Layer 3 Interface (SVI) to Another Switch Deleting a Layer 3 Interface (SVI) or Static Route Disabling Layer 3 Routing Layer 3 Interface (SVI) Caveats Switch Management IP and Layer 3 Interfaces (SVIs) Pings Destined for a Layer 3 Interface Additional ...
On the Layer3 Switch, for Vlan10 we will create an SVI with IP address 10.10.10.10 and for Vlan20 an SVI with IP address 10.20.20.20. These two IP addresses will serve as the default gateway addresses for hosts belonging to Vlan10 and Vlan20 on the Layer2 switches respectively. That is...
Click Initialize layer 3 under the Status section.Enter the following settings: Name: Uplink Subnet: 192.168.128.0/24 Interface IP: 192.168.128.1 VLAN: 20 Default Gateway: 192.168.128.254Click Save.Note: Keep in mind that the management interface (whose IP can be found on the switch's detai...
DHCP server (PC 4) is configured with three IP scopes for clients that connect to VLANs 2, 3 and 4. SW-1 and SW-2 (Catalyst 2950) are used as the Layer 2 switches and L3 (Catalyst 3750) is used as the Layer 3 switch. PCs 1 and 4 are connected in the same VLAN (V...
If the port is configured as a switchport then it will behave as a layer 2 port. If the port is configured as a routed port "no switchport" then it will not be part of a vlan or a trunk. A 3750 without ip routing enabled acts as purely as a L2 switch. Jon 10 Helpful Reply ...
Solved: Hi, I am doing routing on layer 3 my dhcp is on router from that i want to get dhcp on pc which are on different vlan i Have created svi on switch1 vlan 10 10.0.0.1 255.0.0.0 and added ip helper 30.0.0.1 vlan 20 20.0.0.1 255.0.0.0 and added
SNMP v2还定义了两个新的协议操作:GetBulk和Inform。GetBulk操作被用于NMS高效的获取大量的块数据,如表中一行中的多行。GetBulk将请求返回的响应消息尽量多的返回。Inform操作允许一个NMS来发送trap消息给其他的NMS,再接收响应。在SNMP v2,如果agent响应GetBulk操作不能提供list中的全部变量的值,则提供部分的结果。