config—(Optional) Displays switch configuration within the CLI commands supported on the device. Default Configuration By default, this command displays the output of technical-support-related show commands. Use keywords to specify the type of information to be displayed. If you do not...
Line Configuration Mode User Guidelines When this command is enabled, it is activated as follows: connect the console to the device and press theEnterkey twice. The device detects the baud rate automatically. Note that if characters other than Enter are typed, wrong speed might be detected. ...
- Not sure about the counters , this document contains informative show commands related to the stacking : https://www.cisco.com/c/en/us/td/docs/switches/lan/csbms/CBS_250_350/CLI/cbs-350-cli-/stack-commands.html - When the issue happens too often I would dis...
I am using CLI to set my VLAN's and various other settings when setting up a switch for the first time - I paste the text below into PUTTY and one after the other, the commands are dealt with. However, when it gets to the 2nd to last line, interface ... 04-11-2014 6:06:1...
loopback-detection interval show loopback-detection loopback-detection enable (Global) To enable the Loopback Detection (LBD) feature globally, use theloopback-detection enableGlobal Configuration mode command. To disable the Loopback Detection feature, use thenoform of this command. ...
CBS350(config-if-range)#lacp system-priorityvalue 如果要將運行配置儲存到啟動配置,請按照上一節LAG配置過程中的步驟11-13操作。 結論 您現在應該已經透過CLI在介面上配置了LAG。 步驟1.檢驗埠通道是否已建立。使用下面的命令: CBS350磅show interfaces port-channel [int...
https://www.cisco.com/c/en/us/td/docs/switches/lan/csbms/CBS_250_350/CLI/cbs-350-cli-/dhcp-relay-commands.htmlhttps://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-350-series-managed-switches/smb5406-configure-dynamic-host-configuration-protocol-dhcp-snooping.html Any help wo...
https://www.cisco.com/c/en/us/td/docs/switches/lan/csbms/CBS_250_350/CLI/cbs-250-cli/dhcp-relay-commands.html 1 いいね! 返信 Translator Community Manager 2025-02-21 11:50 AM @Translator:次のコマンドを使用して、DHCPリレーがCisco C9300スイッチで動作しているかどうかを確...
number-of-characters- Specifies the number of characters to be displayed for the echo output of the CLI commands and the configuration file,'0' means endless number of characters on a screen line. (Range: 0, 70-512) Default Configuration ...
Tp enable CDP on interface, use thecdp enablecommand in Interface (Ethernet) Configuration mode. To disable CDP on an interface, use thenoform of the CLI command. Syntax cdp enable Default Configuration Enabled Command Mode Interface (Ethernet) Configuration mode ...