Solved: I have deployed 30 Cisco 3702i access points on a Cisco 5508 Wireless LAN controller running IOS code 8.0.140.0. Only 4 out of the 30 are flashing red, blue, and green constantly, but the other 26 are either solid green or solid blue like
I recently connected a new CW9166i-B access point and it's stuck flashing red & green. It successfully authenticates via ISE, gets and IP address but doesn't show up on the WLC. I can ping the IP from the WLC and ping the WLC from the switch. Based on the LED pattern it means...
Red, Green, and Blue User Configurable LED Gigabit Ethernet Combo Port Off — No Link Solid Green — Copper Link up, no activity Flashing Green — Copper Link up, with activity Solid Amber — SFP Link up, no activity Flashing Amber — SFP Link up, with activity RJ45 Fast Ether...
Green, flashing—The SSD is active. Amber—The SSD has a problem or failure. 12 Power Status Off—Input power is not detected. If the AC power cord is plugged in, and the LED on the power supply is blinking green, standby power is still on. Green, flashing—The system has...
New 3802i unable to join WLC 2504, green and red flashing light. Go to solution todorn123 Level 1 08-30-2022 07:37 AM Hello, Attached is complete console log from AP. WLC 2504 Software version is 8.5.171.0. I suspect issue is AP unable to get DHCP but there...
Green, flashing—The system has detected a power switch toggle event, and initiated the shutdown sequence. If the power switch is in the OFF position, the system powers off after shutdown is completed. Do not remove the AC or DC power source while this LED is blinking so that the sy...
Green: SIM1 installed and active Green Flash: Cellular data activity GPS Green, Yellow GPS LED Off: GPS not configured Yellow: Software defined Green: GPS configured Green Flash: GPS acquiring (flashing done by SW) Service Green, Yellow, B...
09-17-2024 Solutions 0Helpful votes Given 5Helpful votes Received User Activity Posts Replies C22 M3 PSU flashing green, no front panel lights Community Statistics Member Since11-30-201103:45 PM Date Last Visited09-17-202402:33 AM ...
Green: SIM1 installed and active Green Flash: LTE data activity GPS Green, Yellow GPS LED Off: GPS not configured Yellow: Software defined Green: GPS configured Green Flash: GPS acquiring (flashing done by SW) Service Green, Yellow, Blue ...
If the LED is flashing amber or green, check the power connections on the power supply and the power source. Verifying the Power Supply Installation Procedure Step 1 Verify the power supply operation by checking the power supply’s front-panel LED. See Power Supply Modules LED...