1 Catalyst 9200 のスタンドアロンおよびスタック構成では、25 のアクセストンネルをサポートできます(ファブリック対応 AP の場合)。Catalyst 9200CX は、IOS-XE 17.9.5 以降を搭載したファブリック対応 AP に対して 25 のアクセストンネルをサポートできます。
Cisco IOS XE Dublin 17.10.x (Catalyst 9200 Switches) 26 Administering the Device Configuring MAC Address Change Notification Traps Step 4 Step 5 Step 6 Command or Action Device(config)# snmp-server host 172.20.10.10 traps private mac-notification Purpose • traps...
I'm going to try to lower the query times in both IGMP and PIM, to see if I notice an improvement, otherwise what I'm going to try is to add a new device to the 9300, to also form a stack, and launch towards them port channels from 9200, and thus try not to change either th...
The Fortigate is my SD-WAN device, and my default gateway for the network. I am using link detection to test HTTP access to google. If my WAN interface cannot get a response from google.com in my set time (5 attempts, with 5 seconds between each attempt) then it will remove the defa...
These configuration steps will change the voice and data VLANs from the default of VLAN 1 to VLANs 11 and 13, respectively, and will add a custom description to the template. Switch> enable Switch# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch(...
• Provision uplink switch with ▪ DHCP Scope with option 43 (pointing to Cisco DNA Center) ▪ Change the PnP startup-vlan (default is vlan 1) PnP uplink switch DHCP scope with Option 43 • Connect the device, Claim the device in Cisco DNA Center Plug and Play • Upgrade ...
interface fc1/1 interface fc1/2 interface fc1/3 interface fc1/4 interface mgmt0 ip address 172.22.95.112 255.255.255.0 no shutdown vsan database boot system bootflash:system-237; sup-1 boot kickstart bootflash:boot-237 sup-1 callhome ip default-gateway 172.22.95.1 switchname switch trunk...
Ensure routes are in place to reach external addresses including a default route (use of ip default-gateway is not supported). IP routing (ip routing) must be enabled on the switch or will be enabled as part of onboarding. Ensure DNS is enabled on the switch (ip name-server ...
11、面3) 冷启动路由器,在开机的前60秒之内,按住“Ctrl+Break”键4) 这时系统会进入灾难恢复模式,其提示符为“Rommon修5) Rommon1>IP_ADDRESS=(设置f0/0口的IP地址为)6) Rommon2>IP_SUBNET_MASK=(设置子网掩码)7) Rommon3>DEFAULT_GATEWAY=54(缺省网关随便设置)8) Rommon4>T(设置TFTP服务器的IP地址54...
Avaya Avaya Media Gateway Belden (Trapeze) Trapeze WLAN Controller MX 800 Brocade Brocade Fibre Switch Brocade Brocade Router Brocade Brocade Switch Brocade Brocade VDX Switch Brocade Brocade SilkWorm 3850 Fabric Switch Brocade Brocade FCX and FWS Switch Calix Occam Blade Switch Calix Calix Switch Cambiu...