In the presence of 2%GTF, the reactor with X-3B solution was sealed and purged with nitrogen in advance to remove dissolved oxygen in the solution. Thus, was only a slightly decrease, about 1%, itnheregmenoevraaltrioanteooff·XO-−23wBowuiltdhobuetstuhpeppreressseedncuenodfe·rOt−2h...
These results evidenced that the treatment with H2O2 was efficient enough to remove, even though not completely, most of the residual carbon layer, which made the saturation magnetization and the heat released by the treated samples significantly greater than that of the untreated carbon-coated ...
powders so that when the slurry is deposited on the substrate, the powder particles will be substantially dispersed on the substrate. The coated substrate should then be heated in an inert atmosphere to first remove the liquid suspending vehicle and further heated to react the tantalum with the ...
As described above, the c-RGD/HA samples were then sonicated for 5 min at room temperature to remove the weakly bound RGD peptides. The aqueous solutions used in the experiments were sterilized using Sigma-Millipore membranes (0.22 µm, Sigma-Aldrich, St. Louis, MO, USA). Table 1 ...
The substrates underwent argon and oxygen plasma cleaning to remove organic contaminants in the sputtering chamber at 10 mTorr pressure with oxygen/argon volume ratio of 1:1. The Ti films were deposited from a 2-inch diameter, 5N purity Ti target, (Abletarget, Beijing, China) by DC ...
The cleaning process applied involved two Catalysts 2019, 9, 323 12 of 16 steps: In the first step, the samples were re-calcined at 400 ◦C for 3 h at a rate of 180 K h−1 under a synthetic air environment to remove the majority of the adsorbed C-containing impurities. In the ...