CC2511_USB_Dongle 使用问题 以上是三张图片, 大体就是 我电脑都能识别到CC2511_USB_Dongle 了 却不能在软件中找到这个, 使用不了, 很纠结 哪位大侠帮我看看啊 你好, 能告诉下,你想做什么事情? 您好, 我是想用这个东西做协议分析, 但是现在就是电脑能识别出嗅探器 就是抓包软件里面没有这个东西。。。 ...
TI公司的CC2510Fx / CC2511Fx是低成本低功耗2.4GHz片上系统(SoC),集成了8051 MCU,存储器,2.4GHz RF收发器,以及USB控制器。可应用于 2400-2483.5 MHz ISM/SRD 频段的系统,消费类电子,无线键盘和鼠标,无线音频,无线体育和休闲设备,低功耗遥感勘测以及USB Dongle.本解决方案介绍了CC2510Fx / CC2511Fx主要性能,...
I bought the CC2510-CC2511 Developpement Kit, and I have only recieved two examples of the CC2511 USB Dongle. I didn't recieve SmartRF04EB yet. I want to connect the two usb dongles using USB RF Modem Example (“rf_modem”) application & I don't find a solution ...
I'm finding the IAR IDE crashing every time I try to debug with the USB dongle attached -- both for the RS232-RF example and the "simple HID" example. I have no issue compiling, but the whole thing augers in ever time i hit the debug button. I can prog...
TI官方2.4G天线设计指导 KEYWORDS • CC25xx • CC24xx • CC2480 • PCB antenna • USB dongle • 2.4 GHz • Inverted F Antenna 上传者:sunowners时间:2019-08-06 TI针对低功耗无线应用推出2.4GHz与1GHz以下RF片上系统解决方案 日前,德州仪器 (TI) 宣布推出一对 RF 片上系统 (SoC) 解决方...
Hello, The module that has the two 10 pin headers in addition to the USB connector. One of the headers is the dedug interface. If so the device can interface with Packet Sniffer by usings a CC-Debugger dongle. CC-Debugger will also provide an interface to IAR, R...
The USB still works with PC, but the RF link between the devices is broken. Per H 14 年多前 in reply to Royston D'souza TI__Expert 6825 points Most likely you have a large frequency offset between the dongle and the transmitter. You can test to increase the RX filter bandwidth to...
2) I selected Simple_Peer_To_Peer.eww under RFUSB 3) I selected target Device for IAR Sample Application : CC2511Link To 4) I generated the .Hex file 5) I programmed the first dongle with the . Hex file 6) I selected target Device for IAR Sample Application...
The difference is that my board does not have a USB interface and I used an external loop antenna instead of the microstrip antenna. I powered my board up and tested every pin on the oscilloscope. The results (voltage, waveform...) are all the same as I tested the dongle. Which I ...
Check the 10-pin cable for correct connections between the USB Dongle and the SmartRF04 P14. The cable might be backwards from the diagram. When the cable is correct and the power is applied to the USB Dongle, the 3 LEDs on the SmartRF04 bd will light...