Connect CAN_ H and CAN_ L is connected to CAN bus, and GND can be connected or not. Plug in the computer, and the CAN device will appear in the device manager Turn on the upper computer Select the required baud rate and sampling point, click OK, and the on-board tri color light ...
You just have to adjust the pot to set the output according to the total forward drop of the LED series string. Meaning, if the total voltage of the LED series is say 3.3V x 50nos = 165V, then adjust the pot to get this output level and then connect it with the LED string. This...
You know as well as I do that when tinkering around you suddenly get a new idea and need x or y :-DAuto shutdownWhen the engine is running and charging the car battery the incoming voltage used to power the board is a little bit higher than when the engine is stopped. This can be...