Chama & H. Abid, Model for calculating the refractive index of a III-V semiconductor, Computational Materials Science, Vol.41, No.4, (2008), pp. 570- 575. http://dx.doi.org/10.1016/j.commatsci.2007.05.023.Anani, M.; Malhieu, C.; Lebid, S.; et al.: Model for calculating ...
The real part of the refractive index. There are three materials in this simulation. 0.1<z<0.5 - Air (index of 1) 0<z<0.1 - Glass (index of approximately 1.5) -0.5<z<0 - Si (index of approximately 4.2) The imaginary part of the refractive index. The imaginary part is a measure o...
We find that two counter-propagating waves in the material must experience the same refractive index, but they can have dramatically different wave impedances. The use of our model in practice is demonstrated with a particular example of a bifacial nanomaterial that exhibits a directional impedance...
The refraction inside fibres is formulated into the calculation, removing the need for refractive index matching oil in experiments. Refractive indices and diameters of both unclad and clad step-index fibres are recovered from measured scattering patterns.doi:10.1080/09500349514551951...
J.D. Olson, The refractive index and Lorenz-Lorentz function of fluid methane. J. Chem. Phys. 63, 474–484 (1975). https://doi.org/10.1063/1.431127 94. J.E. Orrit, J.M. Laupretre, Density of liquefied natural gas components, in Advances in cryogenic engineering...
However, in EUV exposure, EUV light does not pass through the refractive lens due to a relation between a light absorption and a refractive index. For this reason, in an EUV exposure apparatus, a conventional refractive lens cannot be used, and a catoptric system such as a mirror is used....
Preprocessing of the data and data selection the refractive index (nPIOL) was back-calculated based on the Gullstrand formula assuming a refractive index of aqueous humor of nA = 1.336 derived from the schematic model eye of Liou & Brennan [20]. From the 29 PIOL designs with ...
(1972). A high-pressure microviscometer based on refractive index, Proc. R. Soc., Ser. A, 331, pp. 171-184. Wong, P., Lingard, L. S. & Camerson, A. (1992). The high pressure impact microviscometer, STLE Tribology Trans., 35(3), pp. 500-508. Astrom, H. & Venner, C. H...
5、nd relative density (specific grav-ity), and refractive index are the only experimental datarequired for use of this test method.1.3 This practice is useful for determining the carbon-typecomposition of electrical insulating oils of the types commonlyused in electric power transformers and transmis...
Just click into the diagram to change a profile! Guided modes: get the properties of the guided modes calculated: indices l and m (LPl,m modes), effective refractive index, phase constant, effective mode area, fraction of power propagating within the fiber core, cut-off wavelength. The mode...