broadcast-suppressionpacketspackets-per-second undo broadcast-suppression 参数说明 参数 参数说明 取值 packetspackets-per-second 指定每秒包速率。 整数形式,单位是pps。取值范围0～14881000。 视图 GE接口视图、MultiGE接口视图、XGE接口视图 缺省级别 2:配置级 ...
undo traffic-optimize broadcast-suppression rate-threshold命令用来恢复AP的多播报文限速阈值为缺省值。 缺省情况下,限速阈值为256pps。 命令格式 traffic-optimize broadcast-suppressionotherrate-thresholdthreshold-value undo traffic-optimize broadcast-suppressionotherrate-threshold ...
broadcast-suppression pps 0是抑制广播风暴还是不抑制 2024-07-19提问 举报 (0) 最佳答案 zhiliao_sEUyB 抑制 undo broadcast-suppression是不抑制 2024-07-19回答 评论(0) 举报 (0) 0 个回答 按时间 按赞数 该问题暂时没有网友解答 编辑答案分享扩散: 网站相关 关于我们 服务条款 帮助中心 经验与权限 ...
broadcast-suppression auto-detectpacketspackets undo broadcast-suppression auto-detect Parameters Parameter Description Value packetspackets Specifies the rate limit for broadcast packets. The value is an integer that ranges from 64 to 1024, in pps. ...
broadcast-suppression auto-detectpacketspackets undo broadcast-suppression auto-detect Parameters Parameter Description Value packetspackets Specifies the rate limit for broadcast packets. The value is an integer that ranges from 64 to 1024, in pps. ...
Theundo broadcast-suppression auto-detectcommand restores the default rate limit for broadcast packets during intelligent flow control. By default, the rate limit for broadcast packets is 256 pps. This function is not supported by the following models: ...
Theundo broadcast-suppression auto-detectcommand restores the default rate limit for broadcast packets during intelligent flow control. By default, the rate limit for broadcast packets is 256 pps. This function is not supported by the following models: ...
broadcast-suppression auto-detectpacketspackets undo broadcast-suppression auto-detect Parameters Parameter Description Value packetspackets Specifies the rate limit for broadcast packets. The value is an integer that ranges from 64 to 1024, in pps. ...
Setting the bandwidth percentage is the same as setting the rate limit in pps. Take an interface of 10 Gbit/s as an example. If the bandwidth percentage is set to 50%, the device converts the bandwidth percentage to rate limit in pps as follows: (10000 x (50/100) x 1000 ...
Setting the bandwidth percentage is the same as setting the rate limit in pps. Take an interface of 10 Gbit/s as an example. If the bandwidth percentage is set to 50%, the device converts the bandwidth percentage to rate limit in pps as follows: (10000 x (50/100) x 1000 ...