在将VM镜像文件导入时,开机后使用ifconfig命令找不到网卡,使用service network restart命令报错如下 解决方法: 1、修改网卡 ifcfg-eth0配置文件 路径:/etc/sysconfig/network-scripts/ifcfg-eth0 注释掉HWADDR和UUID两项,我这里没有UUID这项 2、删除 70-persistent-net.rules 文件 路径:/etc/udev/rules.d/70-per...
1、运行setup,选择Network Configuration，正确配置网卡 2、确认网线是通的
Error bring network interface up: platform-linux: do-add-ip4-route[x: xx.xxx.xxx.0/24 100]: failure 101 (Network is unreachable) Solution Verified- UpdatedJune 14 2024 at 3:30 PM- English Issue When trying to bring up one of the network interfaces the following error is encountered. ...
1. Online the Group Network2. Both interfaces eth1 and eth7 are enabled. ifconfig command shows that both interfaces are up and running. Ports are blinking green. 2. Disconnect the network cable from interface eth1. The IP is failed over to interface eth7. However, the interfac...
在嵌入式Linux系统的bringup过程中,操作系统内核的加载是一个关键环节。它不仅涉及到硬件与软件的紧密协作,还反映了我们对系统稳定性和效率的深刻认识。正如《黑客与画家》中所说:“好的软件,像是诗一样,是作者对美好世界的思考。” 操作系统内核的加载过程,正是这种美好世界思考的具体体现。
需要大量的Linux虚拟机的情况下,使用vmware克隆了3台虚拟机,配置网卡的时候出现报错:"Bring up interface eth0:Device eth0 does not seem to be present,delaying initialization”。 错误如下图 device_eth0_does_not_seem 解决方法简单,如下三步 第一步:删除文件70-persistent-net.rules ...
先看log里说哪个网卡没有UP起来: [root@localhost network-scripts]# cat /var/log/messages | grep network Mar 7 03:05:18 localhost kernel: drop_monitor: Initializing network drop monitor serviceMar 7 03:05:19 localhost systemd-udevd[413]: renamed network interface eth1 to enp1s0f1Mar 7 03:...
Could not load file'/etc/sysconfig/network-scripts/ifcfg-lo'Mar 13 23:51:35 centos7 network: [ OK ]Mar 13 23:51:36 centos7 network: Bringing up interface eth0: Error: Connection activation failed: No suitable device found ...
按照提⽰输⼊systemctl status network.service查看 [root@centos7 ~]# systemctl status network.service ● network.service - LSB: Bring up/down networking Loaded: loaded (/etc/rc.d/init.d/network; bad; vendor preset: disabled)Active: failed (Result: exit-code) since Mon 2017-03-13 23:...
$sudo pico /etc/network/interfaces 这就会启动简单文本编辑器来编辑Linux网络配置文件 在这里你应该会看到如下内容: auth lo iface lo inet loopback 这个正是lo回环,我需要让这台运行Ubuntu Server的机子通过DHCP获得IP来加入网络,那么我只需要在上面的lo回环的配置内容下面加入: auth eth0 iface eth0 inet dhc...