Midland New Braunfels North Dallas Northloop Northwest Olmos Park Pearland Plano Richardson River Oak Rockwall Rosenberg Round Rock San Angelo San Antonio (Braun) San Antonio (De Zavala) San Antonio (North Central) San Antonio (San Pedro) San Antonio West San Marcos ...
The height of these structures is 5 μm and 50 μm in height, respectively. A mixture of a base and a curing agent with a 10:1 weight ratio (SYLGARD 184 A/B, Dowcorning, Midland, MI) was poured onto the SU-8 mold and cured at room temperature under vacuum for one hour and...
dependent on both field frequency and cellular electrical properties26. The DEP system employed here measures the response of ~20,000 cells per test, using 20 different frequencies in parallel27(Fig.1a), and has been used in a range of cellular applications including drug ...
seal pouches and other packaging applications. It is available as 3.0 or 4.0 mil., natural color, medium slip, also available with one side corona treatment, in widths from 6 inches to 80 inches. (Dow Plastics, “Films and Engineered Laminates”, 1989, Dow Chemical Company, Midland, Mich....
(SYLGARD 184 Silicone Elastomer, Dow Corning Corporation, Midland, MI, USA) were mixed in a 10:1 ratio and PDMS chips were molded from the wafer. After an intermediate cleaning step, the PDMS chip and a glass substrate were surface-activated via oxygen plasma and covalently bonded to each ...
Poly (dimethylsiloxane) (PDMS, Dow Corning, Midland, MI, USA) pre-polymer and curing agent were mixed (ratio: 10:1) appropriately, poured onto the master template, and then cured for 2 h at 80 °C. Subsequently, the PDMS mold was peeled from the master template, and punctured to create...
Based on the protocol reported in a previous study [22], a polydimethylsiloxane (Sylgard 184, Dow Corning, Midland, MI, USA) microfluidic device was fabricated using the soft lithography technique. To stabilize the pulsatile blood flows generated by the micropump, an air damper was connected to...
(SYLGARD 184 Silicone Elastomer, Dow Corning Corporation, Midland, MI, USA) were mixed in a 10:1 ratio and PDMS chips were molded from the wafer. After an intermediate cleaning step, the PDMS chip and a glass substrate were surface-activated via oxygen plasma and covalently bonded to each ...
PDMS replicas were obtained by curing a degassed mixture of Sylgard 184 Silicone Elastomer Base and the Curing Agent 10:1 (Dow Corning, Midland, TX, USA) poured onto both molds and cured at 65 °C, 4 h in an oven. After separating the PDMS replica from the mold, inlet and outlet hole...
Using a Parylene-C Labcoater series 300 (Plasma Parylene Systems GMBH, Rosenheim, Germany), a 10 µm thick layer of Parylene-C was deposited on two different substrates: glass and Polydimethylsiloxane (PDMS, Sylgard 184, Dow Chemical Company, Midland, MI, USA). Thin glass coverslips (1 ...