仲裁协议是规定的,但是仲裁算法可以根据应用决定。 Decoder:负责对地址进行解码,并提供片选信号到各Slave。 每个AHB都需要1个仲裁器和1个中央解码器。 图4‑8 AHB的组成 AHB基本信号 HADDR:32位系统地址总线 HTRANS:M指示传输状态,NONSEQ、SEQ、IDLE、BUSY HWRITE:传输方向1-写,0-读 HSIZE:传输单位 HBURST:传...
RRESP[1:0],读传输 BRESP[1:0],写传输 OKAY(‘b00):正常访问成功 EXOKAY(‘b01):Exclusive 访问成功 SLVERR(‘b10):从机错误。表明访问已经成功到了从机,但从机希望返回一个错误的情况给主机。 DECERR(‘b11):译码错误。一般由互联组件给出,表明没有对应的从机地址。 1.1.2AMBA概述 AMBA (Advanced Mic...
额外信号WSTRB(m-s)(字节屏蔽),用在多字节传输中,若WSTRB中某位字节为1,则说明响应的数据可以被传输到目标地址,若为0,则屏蔽 RDATA(从到主流向)RVALID(s-m) 和RREADY 额外信号RRESP[1:0]一般四种状态 00:ok 01:AXI-lite中没有 10:slaver Error 11:decoder error 4.保证data安全传输 Write sponse(B)...
左图为写传输失败最后一个传输周期,PSLVERR信号拉高,右图为读传输失败,没有读出数据。 AXI桥接到APB: AXI的RRESP/BRESP= APB的SLVERR(read:PSLVERR->RRESP[1], write:PSLVERR->BRESP[1]) AHB桥接到APB:PSLVERR被映射到HRESP= ERROR(PSLVERR -> HRESP[0]) V2.0 AHB是第二代AMBA协议最重要的一部分。AHB...
ACLK为axi总线时钟,ARESETN是axi总线复位信号,低电平有效;读写数据与读写地址类信号宽度都为32bit;READY与VALID是对应的通道握手信号;WSTRB信号为1的bit对应WDATA有效数据字节,WSTRB宽度是32bit/8=4bit;BRESP与RRESP分别为写回应信号,读回应信号,宽度都为2bit,‘h0代表成功,其他为错误。
Search or jump to... Search code, repositories, users, issues, pull requests... Provide feedback We read every piece of feedback, and take your input very seriously. Include my email address so I can be contacted Cancel Submit feedback Saved searches Use saved searches to filter your...
and that slaves were sorted on thebusby how long they would take to respond to a request–so that the fastest responding slaves were always at lower addresses. I handled this byinsisting, within the instruction decoder, that any string of memory operations had to be to either the same addres...