If the cost style of the system is wide or wide-compatible: When auto-cost enable command is configured, Interface cost = (Bandwidth-reference/Link-bandwidth) x 10. The cost style is set by the cost-style command. The Bandwidth-reference is set by the ipv6 bandwidth-reference command. The...
# sysname LSRA # mpls lsr-id 1.1.1.9 mpls mpls te mpls te auto-frr mpls te srlg path-calculation preferred mpls rsvp-te mpls te cspf # explicit-path pri-path next hop 172.21.1.2 next hop 172.22.1.2 next hop 3.3.3.9 # interface GigabitEthernet1/0/0 ip address 172.21.1.1 255.255.255....
calculation of an initial spillover matrix based on robust linear regression, and iterative refinement to reduce error. Moreover, autofluorescence can be compensated out, by processing it as an endogenous dye in an unstained control. AutoSpill uses single-color controls and is compatible with common...
The exponential growth of various complex images is putting tremendous pressure on storage systems. Here, we propose a memristor-based storage system with an integrated near-storage in-memory computing-based convolutional autoencoder compression network
•If the tunnel bandwidth was explicitly configured via the tunnel mpls traffic-eng bandwidth command after the running configuration was written (if at all) to the startup configuration, the "configured bandwidth" is the bandwidth specified by that command. •Otherwise, the "configured bandwidt...
The key features of the DPCM/PCM compression algorithm are: • visually lossless • low cost implementation (no line memories are required) • fixed rate compression The 10-bit to 8-bit DPCM/PCM image compression algorithm is supported by VB6955CM. 10-bit to 8-bit compression has the ...
AD Site Cost Calculation AD Sites and Services - adding subnets AD Sites and Services and subnet question AD sites vs LdapSrvPriority for LDAP services AD sites with no subnets listed AD Troubleshooting... AD Trust - Conditional forwarder aganist secondary DNS zones AD Trust and Required Ports ...
A scaling factor for adjusting the particle resolution before the mesh is generated. Higher values create more high-frequency detail at a cost of longer calculation times. <MaxLiquidSolver>.meshing_holeKillThreshold : float<MaxLiquidSolver>.meshingHoleKillThresholdTab : float array ...
exclusive or shared bandwidth. If Use ELB is selected during the creation of an AS group and an EIP is bound to ELB, all ECSs in the AS group can access the Internet through ELB. You do not need to use the EIP during the creation of an AS configuration. ...
supplementary PD optimization ID (internal book-keeping ID for future reference) new relative cost if WA is accepted. Confidence interval A value between 0 and 1 1 means cost was computed with most accurate data driven tool flow 0 means cost was estimated roughly and is very likely to be ...