solution annealedpost-implantation annealedirradiation-assisted stress corrosion crackingslow strain rate testpressurised water reactorThe susceptibility to irradiation-assisted stress corrosion cracking (IASCC) at relatively low dose is dominated by conventional mechanisms such as radiation-induced segregation, ...
After deposition, the rest of the solutionwas dried at 100 °C, providing powders with the same composition as the thin films. 700 °C为4 h在干燥氧气涨潮之下为了获得终于,薄膜层数锻炼在700 °C为4 h在干燥氧气涨潮之下为了得到期望结构。 在证言以后, solutionwas的其余烘干了在100 °C,提供粉末以...
solution annealedpost-implantation annealedirradiation-assisted stress corrosion crackingslow strain rate testpressurised water reactorThe structural integrity of the reactor pressure vessel (RPV) of light water reactors (LWR) is of utmost importance regarding operation safety and lifetime. The fracture ...
The precipitation characteristics of tetrahedrally close-packed (TCP) phases during the welding and the subsequent solution annealing process of Alloy 22 1 1/2" thick plate double-U prototypical welds are investigated. Electron backscatter diffraction (EBSD) was used to provide large scale ...
In this research, the electrochemical properties of a stir cast Al-0.65Mg-0.15Sn-0.05Ga (wt.%) alloy as an anode material in 3 wt.% NaCl solution was examined by potentiodynamic polarization and electdoi:10.1007/s11581-017-2099-5Sovizi, M. R....
In this work, the mechanical properties and microstructure evolution of the as-annealed and solution treated 2195 alloy specimens under dynamic compression were studied and compared. The dynamic compression tests were performed at the strain rates of 1400 s 1 , 2200 s 1 , 3400 s 1 , and 4500...
The correctness of the EIS results was confirmed by Kramers鈥揔ronig transformation, while fitting of the data (Nyquist and Bode diagrams) to suitable equivalent electrical circuits showed that the highest corrosion enhancement is achieved for the Ni/Cu sample annealed at 473K, resulting in a 98...
In this research, the electrochemical properties of a stir cast Al-0.65Mg-0.15Sn-0.05Ga (wt.%) alloy as an anode material in 3 wt.% NaCl solution was examined by potentiodynamic polarization and electrochemical impedance spectroscopy (EIS). The corrosion behavior of the material was also ...
NaCI solutionElectrochemical corrosion of as-cast and annealed zirconium-based bulk metallic glass (BMG) Zr4_8Cu36Al_8Ag8 in 0.1 M NaCl solution was investigated in this work. The as-cast specimen, in complete amorphous form, contained null percent of crystal phase (denoted as OC); however,...