//Insert a value into an array, and shift it down removing //the first value if array already full void insert(int val, int *avgs, int len) { for (int i = 0; i < len; i++) { if (avgs[i] == -1) { avgs[i] = val; return; } } for (int i = 1; i < len; i+...
}if(!RS485.setPins(-1, -1, -1, RS485_RTS_PIN)) {//-1 保持引脚不变Serial.print("Failed to set RS485 pins"); }///esp_err_t uart_set_line_inverse(uart_port_t uart_num, uint32_t inverse_mask)uart_set_line_inverse(RS485_SerialNum, UART_SIGNAL_RTS_INV);//特殊,修改输出或输...
value1 - value2; result = value1 * value2; result = value1 / value2; Parameters: value1: 任何常量或者变量,value2: 任何常量或者变量 编程小提示 整型常量的默认值是 int 类型,所以一些整型常量(定义中)的计算会导致溢出.(比如: 60 * 1000 会得 到一个负数结果.那么 if(601000>0),if得到的是一...
GPIO脚配置 //#define TFT_RST -1 // Set TFT_RST to -1 if the display RESET is connected to NodeMCU RST or 3.3V// ### EDIT THE PIN NUMBERS IN THE LINES FOLLOWING TO SUIT YOUR ESP32 SETUP ###// For ESP32 Dev board (only tested with ILI9341 display)// The hardware SPI can b...
Arduino 的程序可以划分为三个主要部分:结构、变量(变量与常量)、函数。 Arduino 的程序可以划分为三个主要部分:结构、变量(变量与常量)、函数。 结构部分 一、结构 1.1 setup() 1.2 loop() 二、结构控制 2.1 if 2.2 if...else 2.3 for 2
\AndréOViking\Projetos\Washing_Machine_Interface\washing-machine-interface\WM_Interface\Washing_Machine_Interface\Washing_Machine_Interface\Communication\Arduino\ArduinoProtocol.cs:line67at Washing_Machine_Interface.MainWindow.Pin2Slider_ValueChanged(Object sender,RoutedPropertyChangedEventArgs`1 e) in D:\...
const updateValue = (el, value, updateRemote) => { updateRemote = updateRemote == null ? true : updateRemote let initialValue if (el.type === 'checkbox') { initialValue = el.checked value = !!value el.checked = value } else { initialValue = el.value el.value = value } if (upda...
PT100有一个标准的阻值温度对应表，在0度的时候，它的电阻值在100R，在常温25℃，它的电阻值是109....
value back to ENABLE register */ if ( !wireWriteDataByte(APDS9930_ENABLE, reg_val) ) { return false; } return true; } /** @brief Starts the light (Ambient/IR) sensor on the APDS-9930 @param[in] interrupts true to enable hardware interrupt on high or low light @return True if ...
if(secondHand==55){currentPalette=myRedWhiteBluePalette_p;currentBlending=LINEARBLEND;} } } // This function fills the palette with totally random colors. voidSetupTotallyRandomPalette() { for(inti=0;i<16;i++){ currentPalette[i]=CHSV(random8(),255,random8()); ...