It uses directional communications allowing you to point one or more of your 3 Antennas at the WiFi device or devices you are using to get a stronger signal. Where as standard routers use omni-directional which basically forms a signal circle around the router. This Archer C9 has four 1gig...
NOTE: If the router is configured as an access point, then the second option, Allow Guest to access my Local Network, should be checked by all means. Otherwise, the guests cannot get Internet access. The explanation of the above 3 options: 1. Allow Guest to access To See Each Other: ...
NOTE: If the router is configured as an access point, then the second option, Allow Guest to access my Local Network, should be checked by all means. Otherwise, the guests cannot get Internet access. The explanation of the above 3 options: 1. Allow Guest to access To See Each Other: ...
Symptoms: all the LEDs are ON, and you can't access to UI Download the applicable stock firmware for your device From the official v1-page, v2-page, v3-page, OR v4-page. * Rename the downloaded firmware with the following name: archerc9v1_tp_recovery.bin, archerc9v2_tp_recovery....
Archer C9 AC1900 Wireless Dual Band Gigabit Router 5) The following TCP/IP Properties window will display and the IP Address tab is open on this window by default. 6) Select Obtain an IP address automatically and Obtain DNS server automatically, as shown in the Figure below: Figure B-3 2...
I have another router conected to the modem and when I run the test I get 48MBPS ...when I run with the archer c9 I only get 24MBPS max(I live in ecuador so the velocitys here are slow yet)... then I disconect the openVPN option and the same...never get more than 24MBPS ...
"name": "hexo-theme-archer", "version": "1.5.0", "lockfileVersion": 1, "requires": true, "dependencies": { "@babel/code-frame": { "version": "7.0.0-beta.39", "resolved": "https://registry.npm.taobao.org/@babel/code-frame/download/@babel/code-frame-7.0.0-beta.39.tgz", "...
NOTE: If the router is configured as an access point, then the second option, Allow Guest to access myLocal Network, should be checked by all means. Otherwise, the guests cannot get Internet access. The explanation of the above3options: ...
At this point I decided to go back. I attempted to flash back to stock (oldorgArcherC9_v1_tprecovery.bin) from the DDWRT webgui which completed and the router rebooted. Nothing appeared to have changed. I setup a TFTP server, set my the local IP to 192.168.0.66, and put the ...
NOTE: If the router is configured as an access point, then the second option, Allow Guest to access my Local Network, should be checked by all means. Otherwise, the guests cannot get Internet access. The explanation for the above 2 options: ...