When the UPS is off and there is no utility power, it is possible to cold start the UPS to power the loads from the UPS’s battery.Note: Cold start is not a normal condition.• Press and hold the on/test button until the UPS begins beeping.• Release the on/test button during...
Single Beep - a short power loss has occurred and the Back-UPS briefly goes on battery.Four Beeps Every 30 Seconds - this alarm is sounded whenever the Back-UPS is running On Battery. Consider saving work in progress.Continuous Beeping - this alarm is sounded whenever a low battery ...
errorinthebuildingorintheoutletprovidingpowertothe UPS. Alarms AudibleIndicators FourBeepsEvery30Back-UPSisrunningonbattery.Youshouldconsider Secondssavinganyworkinprogress. Lowbatteryconditionandbatteryrun-timeisverylow. ContinuousBeepingPromptlysaveanyworkinprogress,exitallopen ...
On (Off 4 beeps repeated On-Battery - The Back-UPS is supplying battery power during 4 every 30 seconds beeps) Flashing Rapid Beeping Low Battery Warning - The Back-UPS has 2 minutes of runtime remaining (every 1/2 second) Constant tone Bad Battery Detected - The battery needs to be ...
User Manual APC Smart-UPS 2200/3000 VA 100/120/230 VAC Tower Uninterruptible Power Supply English 990-1674C 12/20005 Introduction Introduction About this UPS The APC Uninterruptible Power Supply (UPS) is designed to prevent utility power blackouts, brownouts, sags and surges from reaching ...
The addition of this symbol to either a “Danger” or “Warning” safety label indicates that an electrical hazard exists which will result in personal injury if the instructions are not followed.This is the safety alert symbol. It is used to alert you to potential personal injury hazards. ...
Computers are non-linear loads that cause harmonics to flow in the power lines. Harmonics are currents that are multiples of the fundamental line frequency (50 or 60 HZ). The reason harmonics are a problem is due to two factors: Matrix-UPS helps reduce harmonics problems in the following way...
SAVE THESE INSTRUCTIONS - This section contains important instructions that should be followed during installation and maintenance of the UPS and batteries.Inventory Connect the Battery The UPS is shipped with the battery disconnected.BX850/1000M/M-LM60 Remove the battery door.Remove the battery. ...
When the UPS is "Off" and there is no utility power, it is possible to cold start the UPS to power the loads from the UPS battery. • Press and hold the On/Off/Test button until the UPS begins beeping. • Release the On/Off/Test button during the beeping to start the UPS. ...
Continuous Beeping Promptly save any work in progress, exit all open applications, and shut down the operating system. Continuous tone Battery Backup outputs are overloaded. Chirps every 2 Seconds Battery is disconnected. Battery did not pass the automatic diagnostic test and should Continuous chirping...