Once the uninstallation is done, restart your computer to take effect. If this doesn't solve the stop code APC index mismatch error, something else might be causing the issue. Solution 4: Change your RAM frequency As briefly mentioned earlier, the stop code APC index mismatch could also be ...
DB-9 RS-232, RJ-45 10/100 Base-T, Smart-Slot Control panel LED status display with load and battery bar-graphs and on line : on battery : replace battery : overload and bypass indicators Audible Alarm Alarm when on battery : distinctive low battery alarm ...
CE, CUL listed, EN 55022 class A, FCC part 15 class A, UL listed Send your message to this supplier *From: *To: *Message: Enter between 20 to 4,000 characters. Send This is not what you are looking for? Post a Sourcing Request Now Shenzhen Xingshengtu Inform...
14 6: REGULATORY AND WARRANTY INFORMATION Regulatory Agency Approvals and Radio Frequency Warnings 230V MODELS This is a Class A product. In a domestic environment this product may cause radio interference, in which case the user may be required to take corrective ac- tions. 120V MODELS This ...
One could write a PHP class that takes care of this, and inserts/requests cache entries from/into the different nodes in the pool. It works like a webservice, between the webservers. It allows you to use APC both for local caching, and distributed caching. The same method applies to ...
12 7: REGULATORY AND WARRANTY INFORMATION 110/120 V models This equipment has been tested and found to comply with the limits for a Class A digital device, pur- suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when ...
14 Smart-UPS 2200/3000 VA 100/120/230 VAC Tower User Manual Regulatory and Warranty Information Regulatory and Warranty Information Regulatory Agency Approvals and Radio Frequency Warnings FCC Compliance Notice This equipment has been tested and found to comply with the limits for a Class A digital...
Solution Press the On/Off/Test button to power the UPS and the loads. Reduce the load on the UPS by unplugging equipment and reset the circuit breaker by pressing the plunger back in. Disconnect the computer interface. If the UPS now works normally, check the interface cable and the ...
• CL2: Class 2 cable for general use. • CL2P: Plenum cable for use in ducts, plenums, and other spaces used for environmental air. • CL2R: Riser cable for use in a vertical run in a floor-to-floor shaft. • CLEX: Limited use cable for use in dwellings and for use in...
9 PROBLEM AND/OR POSSIBLE SOLUTION CAUSE BATTERY CHARGE AND LOAD LED BARGRAPHS FLASH SIMULTANEOUSLY The UPS has shutdown. The Check that the room temperature is within the specified limits for operation. internal temperature of the UPS has exceeded the allow- Check that the UPS is properly ...