The tool includes a ball bearing (18) to decouple the bolt (16) from torque. The tool has a thread system enabling the spreading body to be pulled into the spreading shell against an abutment (26).doi:DE102004006376HUSS, RAINERFISCHER, ARTUR...
concrete cone breakout failure, side face blowout failure, concrete splitting, and anchor pull-out. Anchor bolt failure happens when the strength of the anchor is less than the applied tensile stress or the anchor strength is lower than the ultimate load for the other...
the shallow water anchor12is angularly positionable relative to the mounting bracket16by aligning the first hole120with the mounting hole112, and the second hole122with one of the arcuate array of holes114. Once these holes112,114,120,122are aligned, a pin, bolt, or other like fastener123...
Drive the bolt down until the cut washer rests on the foot plate. 6. Tighten the T13 anchor with a 3/4" impact wrench, then use a torque wrench to insure correct tightness. Refer to the chart for proper torquing values. WARNING: If wind loads over 35 miles per hour are experienced ...
After inserting the anchor consisting of a metal sleeve and a threaded bar ending in a cone, a given installation torque is applied. In this process the anchor adapts to the conical void by which mechanical interlock is achieved. A qualitative sketch of the undercut anchor is shown in Figure...