Melting point660.37 °C (lit.) Boiling point2460 °C (lit.) bulk density0.77g/cm3 Density2.7 g/mL at 25 °C (lit.) vapor pressure0.13-1300Pa at 974℃ Flash point400°C storage temp.Flammables area solubilityinsoluble in H2O; soluble in acid solutions, alkaline solutions ...
Working temperature: 1300 - 1800 °C Wall thickness: not less than 2mm Delivery condition Specification Diameter Height Tolerance Diameter Height Thickness Roughness (um) Sintering 10~500 +/-5.0 +/-5.0 8~20 <3.5 Sintering finishing 10~450 +/-0.5 +/-0.5 7~18 <2...
2. Melting Power(KW) 800 3. Rated Capacity of furnace for Iron (kg) 1000 4. Input Voltage (Volts) 400 5. Power Supply : 3 Phase, 50Hz , 400V Yes 6. Rated Working voltage 3000 7. Melting Temperature (°C) 1600 8. Melting time for 1000kg capacity (Minutes)...
force, and (c) pressure. The instantaneous temperature is shown in gray on panel (c). Panel (b) insets show the local atomic structure (green—FCC; gray—disordered; red—HCP) at snapshots before melting, after melting, and after refreezing. Full size image...
High-temperature, pressure-shear plate impact experiments were conducted to investigate the rate-controlling mechanisms of the plastic response of high-purity aluminum at high strain rates (106 s1) and at temperatures approaching melt. Since the melting temperature of aluminum is pressure dependent, and...
It also has a low density (∼2.70 g/cm3) and low melting temperature (∼933 K) (Gil, 2005; Tsakiridis et al., 2013). These characteristics have made this metal as a widely applicable material in the aerospace, building architecture and marine industries (Tsakiridis et al., ...
2.Melting Power(KW)800 3.RatedCapacity of furnace forIron (kg)1000 4.Input Voltage (Volts)400 5.Power Supply : 3 Phase, 50Hz , 400VYes 6.Rated Working voltage3000 7.Melting Temperature (°C)1600 8.Melting time for 1000kg capacity (Minutes)50-55 ...
Melting was studied by differential scanning calorimetry where the powders were heated from room temperature to 750 °C in an argon environment. Thermogravimetric analysis was used to measure the mass increase indicative of oxidation while the powders were he... 展开 关键词:...
2.Melting Power(KW)800 3.RatedCapacity of furnace forIron (kg)1000 4.Input Voltage (Volts)400 5.Power Supply : 3 Phase, 50Hz , 400VYes 6.Rated Working voltage3000 7.Melting Temperature (°C)1600 8.Melting time for 1000kg capacity (Minutes)50-55 ...
Melting point(°C) 2250 Maximum service temperature(°C) 1900 Ture density(g/cm3) 3.9 Abrasives grade Grain: 16#,20#,24#30#,36#,46#,54#,60#,80#,100#,120#,150#,180#,220# Micropowder:240#,280#,320#,360#,400#,500#,600#,800#,1000#,1200#,1500# 2000#,...