需要在setup——User preference editor里设置paths——library，设置devpath，...报错2：WARNING(SPMHNI-337): Unable to load symbol ‘HD6-3_5-PM350-4R06ASM1’ us...找不到pad，
#1 ERROR(SPMHNI-191): Device/Symbol check error detected. ERROR(SPMHNI-195): Symbol 'QFN40P800X800_68' for device 'BCM43217TKMLG-W1000-20892_QFN40' is missing pin 'H'. 表明PCB封装少H脚. 错误种类8: WARNING(SPMHNI-337): Unable to load symbol 'SOT23' for device 'FET-MOS-P_6_SOT23...
WARNING(SPMHNI-337): Unable to load symbol 'SOT-23-3' used by RefDes Q1 for device 'NPN_SOT-23-3_MJD44H11T4G': WARNING(SPMHUT-127): Could not find padstack R110_60. [help] 这个是少了焊盘, 把焊盘复制到padpath路径下即可.
1. 找不到焊盘PAD,下面这句话的意思是器件封装找不到焊盘46.pad WARNING(SPMHNI-337): Unable to load symbol'POWER-JACK3'used by RefDes CON1fordevice'DC-005_POWER-JACK3_DC-005': WARNING(SPMHUT-127): Could not find padstack46. [help] 解决办法把46.pad拷贝到cadence的封装库目录里面 2. 封装...
表明PCB封装少H脚.错误种类8:WARNING(SPMHNI-337): Unable to load symbol SOT23 f 6、or device FET-MOS-P_6_SOT23_DISCRETE_TG21: WARNING(SPMHUT-127): Could not find padstack SMD20_17.#18 WARNING(SPMHNI-192): Device/Symbol check warning detected.这个错误提示找不到SMD20_17这个焊盘,我到自己...
解决了, AB00是自带的SYMBOL,它的PAD文件是放在同一FOLDER內,而我PAD的PATH只指向自已的专用PAD FOLDER...
解决了, AB00是自带的SYMBOL,它的PAD文件是放在同一FOLDER內,而我PAD的PATH只指向自已的专用PAD FOLDER...
报错提示你无法加载flash符号，你找到这个pad文件，然后打开重新指定一下flash文件
due to ERROR(SPMHDB-274): Unable to load flash symbol FC1R10W1R70 (Check PSMPATH setting for this symbol). 错误的意思我理解,不能找到焊盘THC1R10D0R70,原因是不能加载flash symbol FC1R10W1R70,让检查PSMPATH的路径! 首先路径我已经设置过了,以前都用的这里的:E:CADENCESPB_16.3SHAREPCBpcb_libfoot...
allegro中导入封装,提示热风焊盘不存在 Unable to load flash symbol 170 (Check PSMPATH setting for this symbol).W- (SPMHUT-127): Could not find padstack PAD220CIR140D.PAD220CIR140D缺少热风焊盘的flash symbol,导出库的时候没有问题，但是该库缺少170.dra、170.fsm文件，软件自带的也没有(如下图)此时...