Investigation of the Al—Pd—Fe Phase Diagram Between 50 and 100 at.% Al: Ternary Phases.doi:10.1002/chin.200423020equilibriaaluminumAlironFepalladiumPdstructure (solids and liquids)For Abstract see ChemInform
Investigation of the Al—Pd—Fe Phase Diagram Between 50 and 100 at.% Al: Ternary Phases.equilibriaaluminumAlironFepalladiumPdstructure(solidsandFor see ChemInform in Full Text.doi:10.1002/chin.200423020S.Inst.BalanetskyyInst.B.Inst.Grushko
Margolin, “Binary and Ternary Diagrams of the Ti-Al-Cr and Ti-Al-V Systems,” Wright Air Development Division Tech. Rep, 1-20(1960). (Experimental;#) H. Zoller, “The Influence of Zn, Mg, Si, Cu, Fe, Mn and Ti on the Primary Crystallization of Al7Cr,”Schweiz. Arch. Angew. ...
Calculated Al–Fe phase diagram based on CALPHAD modeling by Sundman et al.9. The metastable liquidus and solidus lines are plotted to analyze the formation of non-equilibrium phases from the supersaturated solution phase. One example at 1000 K is shown for phase equilibrium from the supercooled...
by machine learning (ML) to predict the formation enthalpy of σ in several systems. The ML models were trained and tested on binary configurations, and then used to extrapolate data on several Co-Ta-X and Ni-Ta-X (X = Ag, Al, Fe, Ni, Si, Ti, Zn, Zr) ternary configurations....
The evaluation of phase equilibria in quinary systems that constitute the commercially important Al–Cu–Fe–Mg–Ni–Si alloying system is performed in the compositional range of casting alloys by means of metallography, electron probe microanalysis, X-ray diffractometry, differential scanning calorimetry...
Among them, the Al-Cu-Fe ternary alloys have attracted particular attention due to the low cost, easy availability, and recyclability of the constituent elements [5,11,12]. The stable I-AlCuFe icosahedral quasicrystalline phase was first identified by Tsai et al. [13] with a composition of...
Ni-Co-Cr-Al-Fe-based high-entropy alloys (HEAs) have been demonstrated to possess exceptional oxidation resistance, rendering them promising candidates as bond coats to protect critical components in turbine power systems. However, with the conventional
Troc,V. Zaremba.The U-Co-Al Ternary System: Phases Formation and Isothermal Section of the Phase Diagram at 900?°C.Solid State Ionics. 2005H. Noel,O. Tougait,R. Troc,V. Zaremba.The U-Co-Al Ternary System: Phases Formation and Isothermal Section of the Phase Diagram at 900?°C. ...
Isothermal Section (400 °C) of the Phase Diagram of Y—Al—Ga Ternary System in the Region up to 33.3 at.% Y.equilibriaaluminum, Algallium, Gayttrium, Ystructure (solids and liquids)doi:10.1002/chin.200312017M.V.SpekaV.Ya.Markiv