Description: Added more data from BMS showing cell volt low and high, cell temp low and high and high res battery state of change. Checklist: The pull request is done against the latest developme...
Since the DFM-17 programming connector is just an unpopulated group of pads on the circuit board, you will need to either solder wires directly to the pads or alternatively solder a 0.05" (1.27mm) 5-by-2 pin header to the pads. There are suitable ribbon cables with 5x2 0.05" connectors...
However you can also use it for a single cover based on an arduino nano or even ESP8266 board. https://github.com/gryzli133/RollerShutterSplit Member frenck on Jan 10 This is a bare link, please don't use those. Contributor Author gryzli133 on Jan 10 the sketch is built of ...