ADC Calibration not complete, check if device is unlocked and recalibrate.C28xx: Breakpoint Manager: Retrying with a AET breakpoint C28xx: Trouble Setting Breakpoint with the Action "Finish Auto Run" at 0x9000: (Error -1066 @ 0x9000) Unable to set/clear requested breakpoint. Verify that th...
1、ADC Calibration not complete, check if device is unlocked and recalibrate.(2833x系列) 2、 解决方案: 关闭工程,断开仿真器与DSP的连接,并执行如下操作 后连接,仿真器与DSP,装载工程,并执行如下操作: 编译文件,完成正常烧写! 若还不能完成正常烧写,检查build option里linker中的code enter point是否正常,打...
我的程序是原先CCS3.3转过来的，附件是CCS5.5的截图，看下是不是缺少什么文件。编译没有错误，只有在链接芯片的时候报错。我试过其它的小程序，链接芯片都没有问题，使用这种大程序就出错。
;while(adc_calibration_init_status_get(ADC1));adc_calibration_start(ADC1);while(adc_calibration_...
To complete calibration, the user must follow the below procedure: • Configure ADC_CFG with actual operating values for maximum accuracy. • Configure the ADC_GC values along with CAL bit • Check the status of CALF bit in ADC_GS and the CAL bit in ADC_GC ...
Start calibration: set CALBISTREG[TEST_EN]. Wait for calibration to complete. Check MSR[ADCSTATUS] or till CALBISTREG[C_T_BUSY] becomes 0. Check the value of MSR[CALIBRTD] to determine whether calibration was successful. If MSR[CALIBRTD] = 1, calibration was successful; otherwise, it fa...
If the value returned is zero, the conversion is not complete, and this function should be retried until a nonzero result is returned. ADC_WAIT_FOR_RESULT Does not return a result until the ADC conversion is complete. Return Value: uint8: If a nonzero value is r...
I do not recommend to varies VDDA/ VREF+ voltage once ADC is activated, you should always keep them stable when it is active, else re-enable it again. For other STM32F1 as example, the calibration is able to compensate the Offset and you can do it from time to time when temperature ...
// 根据配置值初始化ADC转换器/* Verify ADC */ADC_AutoCalibration(ADC_INSTANCE); // 验证ADC校准...
LED1 blinks */BSP_LED_Toggle(LED1);HAL_Delay(20);}}/*** @brief Conversion complete call...