[n]: y Please specify an IP protocol: tcp Please specify a client IP address: 192.168.10.50 Please specify a client port: Please specify a server IP address: 192.168.11.50 Please specify a server port: Monitoring packet tracer and firewall debug messages 192.168.10.50-41984 - 192.168....
Cisco Packet Tracer的ip控制1.access-list 101 deny tcp 192.168.2.0 0.0.0.255 host 192.168.1.222 eq 20会禁止所有ip段访问。2.然而access-list 101 permit ip any any这句一加,所有的又都可以访问了。求大神指点,我快疯了。。。 分享5赞 合肥it外包吧 低调的奥特曼9 出口路由配置Router(config-if)#ip...
The IEEE 802.2 Logical Link Control packet. You can control access based on the Destination Service Access Point address. The following types of traffic are not supported: 802.3-formatted frames—These frames are not handled by the rule because they use a length field as opp...
https://www.firewall.cx/cisco/cisco-routers/cisco-router-vpn-client.html I am also attaching the final running config so you can see what I entered. Kudos to you for sticking with me and helping to point me in the right direction. I couldn't have done this without you and I thank ...
My filed is radio communication and I have limited knowledge of Cisco equipment. Point is that I have IP cameras around wide land area and they are connected with radio links. This is a strictly private network without access to the internet, only dedicated end users can see those IP ...
Cisco Firewall :: ASA 8.4(3) - Access To Public IP Address From Inside May 22, 2012 I need to connect from an inside host to a host located in the DMZ zone for DNS queries. The host in the DMZ zone has a static NAT to the outside. The point now is that I would...
you will see that the remote site will load balance between the two upstream routers as it is right now. From there you can tweak the metrics using metric-type E1 to decide what device should be used as an exit point. I have done this in the real world, so I know it's a viable ...
In this case, there is no chance of flooding the ARP packet out of all the ports. The issue with the multicast mode is virtual IP address becomes unreachable when accessed from outside the local subnet because Cisco devices do not accept an arp reply for a unicast IP address that c...
you will see that the remote site will load balance between the two upstream routers as it is right now. From there you can tweak the metrics using metric-type E1 to decide what device should be used as an exit point. I have done this in the real world, so I know it's a viable ...
The IEEE 802.2 Logical Link Control packet. You can control access based on the Destination Service Access Point address. The following types of traffic are not supported: 802.3-formatted frames—These frames are not handled by the rule because they use a length field as opposed to...