用之前要定义，可能你的那个aaa是个局部变量，导致后面的程序无法访问，才会这样的吧
用之前要定义，可能你的那个aaa是个局部变量，导致后面的程序无法访问，才会这样的吧
The value is of the Boolean type: true: The device continues sending accounting packets. false: The device does not send accounting packets. The default value is false. N/A /huawei-aaa:aaa/authorization-scheme/authorization-mode Indicates the authorization mode in an authorization scheme. The ...
The value is of the Boolean type: true: The device continues sending accounting packets. false: The device does not send accounting packets. The default value is false. N/A /huawei-aaa:aaa/authorization-scheme/authorization-mode Indicates the authorization mode in an authorization scheme. The ...
RADIUS was defined earlier than the AAA framework model, and RADIUS combines authentication and authorization. Therefore, when AAA is implemented through RADIUS, the user may not know whether the access is denied because of an authentication failure (for example, the password is incorrect) or an ...
By default, a system-defined user group exists. The group name is system. 3. Configure authorization attributes for the user group. authorization-attribute { acl acl-number | callback-number callback-number | idle-cut minutes | ip-pool ipv4-pool-name | ipv6-pool ipv6-pool-name | ipv6-...
Specify the Layer 2 Ethernet interfaces if portal is enabled on VLAN interfaces and the portal roaming enable command is not configured.To configure local user attributes:Step Command Remarks 1. Enter system view. system-view N/A 2. Add a local user and enter local user view. local-user...
Cannot configure login block-for setting while device is in Quiet-Mode. Example 3- The following example displays an failure to configure command. Failure reason: quiet-mode access class (default or user defined) is not configured: switchxxxxxx(config)#login block-fo...
NameError: name 'a' is not defined 1. 2. 3. 4. 5. NameError 名称错误 原因及解决方案: 先给a赋值,才能使用它。当出现NameError时,绝大多数情况不是没被赋值,而是我们将单词拼错,或大小写没注意到。因此要回头好好检查下哪里错了。 SyntaxErrorError ...
Cannot configure login block-for setting while device is in Quiet-Mode. Example 3- The following example displays an failure to configure command. Failure reason: quiet-mode access class (default or user defined) is not configured: switchxxxxxx(config)#login block-for770attempts7within613 ...