The following table provides location codes for parts that comprise the system control unit. Table 1. FRU locations for the system control unit Failing item namePhysical location codeIdentify LED System unit Un Fans Fan 1 Un-A1 Yes Fan 2 Un-A2 Yes Fan 3 Un-A3 Yes Backplane System backpl...
IBM recommends that adapters that do not require high bandwidth be placed in anEMX0 PCIe3 expansion drawer. Populating a low latency, high-bandwidth slot with a low-bandwidth adapter is not the best use of system resources. From a system resource perspective, the best location for a low-band...
Document Location Worldwide [{"Business Unit":{"code":"BU058","label":"IBM Infrastructure w\/TPS"},"Product":{"code":"HW1A1","label":"Power Systems"},"Platform":[{"code":"PF002","label":"AIX"}],"Line of Business":{"code":"LOB57","label":"Power"}}] Was ...
Plug the UPIC cable(A)into the previously identified location in the system control unit by inserting the cable into the connector until it locks into place. Figure 2. Replacing the UPIC cable into the system control unit Push the white plastic lock(B)onto the plug housing. ...
Either return the device to its original location or move the device while the adapter is powered off or unconfigured. A SAS device has been improperly replaced by a SATA device. A SAS device must be used to replace a SAS device. When the problem is resolved, go to Verifying a repair....
1– extended reference code information 11 17–24 ffff Frame location 1– extended reference code information 11 25–32 bbbb Board position 2 12 1–8 MIGVEP62 or MIGVEP63 See System Reference Code (SRC) Format Description . 3 12 9–16 cccc cccc Component reference code 4 12 17–24 pppp...
For more information about failing part numbers, location codes, or removal and replacement procedures, seePart locations and location codes. Select your machine type and model number to see applicable procedures for your system. Attention:There is data in the cache of this I/O card, that belong...
In the PowerVM Open I/O mode, thePowerVM NovaLinkpartition is designated as the service partition. Copy the firmware to a temporary location in thePowerVM NovaLinkpartition. Run the following command on the service partition, wherefirmware_pathis the location of the firmware in the service parti...
The following table provides location codes for parts that comprise the system control unit. Table 1. FRU locations for the system control unit Failing item namePhysical location codeIdentify LED System unit Un Fans Fan 1 Un-A1 Yes Fan 2 Un-A2 Yes Fan 3 Un-A3 Yes Backplane System backpl...
The following table provides location codes for parts that comprise the system control unit. Table 1. FRU locations for the system control unit Failing item namePhysical location codeIdentify LED System unit Un Fans Fan 1 Un-A1 Yes Fan 2 Un-A2 Yes Fan 3 Un-A3 Yes Backplane System backpl...