The IBM PowerLinux 7R1 (8246-L1T) is based on POWER7 processor-based technology. This server uses the Linux operating system. Use this information to find the system overview and the planning, installing, removing, replacing, configuring, and troubleshoo
1331F578P06391 - 3216 GB, 1066 MHz DDR3 DIMM (8246-L1C,8246-L1S,8246-L2C,or8246-L2S) 1331FA78P19141 - 328 GB, 1066 MHz DDR3 DIMM (8246-L1D,8246-L1T,8246-L2D,or8246-L2T) 1331FB78P19151 - 3216 GB, 1066 MHz DDR3 DIMM (8246-L1D...
Learn how to cable your IBM PowerLinux 7R1 (8246-L1C, 8246-L1D, 8246-L1S, or 8246-L1T) or IBM PowerLinux 7R2 (8246-L2C, 8246-L2D, 8246-L2S, or 8246-L2T) to a console, terminal, or interface, such as the Advanced System Management Interfac...
Learn how to remove or replace the storage interposer card in the IBM PowerLinux 7R1 (8246-L1C, 8246-L1D, 8246-L1S, or 8246-L1T) and the IBM PowerLinux 7R2 (8246-L2C, 8246-L2D, 8246-L2S, or 8246-L2T).
8246-L1S, 8246-L1T, 8246-L2C, 8246-L2D, 8246-L2S, or 8246-L2T Use this procedure to install new or upgraded memory modules. The following installation procedure is intended for installing a new or upgraded memory module. Before installing or replac...
For instructions, see Disconnecting the power cords from the 8246-L1C, 8246-L1D, 8246-L1S, 8246-L1T, 8246-L2C, 8246-L2D, 8246-L2S, or 8246-L2T system.Disconnect the power cable (A) from the front of the power supply as shown in Figure 1. Figure 1. Removing the po...
8246-L1C, 8246-L1D, 8246-L1S, 8246-L1T, 8246-L2C, 8246-L2D, 8246-L2S, or 8246-L2T Use this procedure to install new memory risers. This installation procedure is intended for installing a new memory riser (also known as memory ...
Note the state of the light-emitting diodes (LEDs) on the power supply. For more information, seePower supply LEDs for the8246-L1C,8246-L1D,8246-L1S,8246-L1T,8246-L2C,8246-L2D,8246-L2S,or8246-L2T. If the LEDs indicate that the power supply is operating normally,...
Align the RAID/cache storage controller with the slot in the system. Slide the RAID/cache storage controller fully into the system until the tab(A)locks into place. Figure 1. Replacing a RAID/cache storage controller in an8246-L1C,8246-L1T,8246-L2C,8246-L2D,8246-L2T...
Use this procedure to remove and replace the media devices in the IBM PowerLinux 7R1 (8246-L1C, 8246-L1D, 8246-L1S, or 8246-L1T) and the IBM PowerLinux 7R2 (8246-L2C, 8246-L2D, 8246-L2S, or 8246-L2T) servers.