Switch(config-if)#switch trunk encapsulation dot1qSwitch(config-if)#switchport mode trunkSwitch(config-if)#
Switch(config-if)#switchport mode trunk Command rejected: An interface whose trunk encapsulation is "Auto" can not be configured to "trunk" mode. 解决方法: Switch(config-if)#switchport trunk encapsulation dot1q Switch(config-if)#switchport mode trunk 先配置封装,再设置trunk...
Cisco三层交换机端口设置trunk方法 Command rejected: An interface whose trunk encapsulation is "Auto" can not be configured to "trunk" mode. 问题症状: Switch(config-if)#switchport mode trunk Command rejected: An interface whose trunk encapsulation is "Auto" can not be configured to "trunk" mode....
in cisco switches the command switchport trunk allowed vlan all is the default when you configure a port as a trunk so it is enogh to use int gi1/1/3 switchport mode trunk on both sides of the link using a port-channel if possible is recommended. in case LACP is far better then unco...
In this article we will examine Access Mode and Trunk Mode ports on Cisco switches. What is “switchport mode access” This is the command that configures the port of the switch in Access Mode. It is used to connect single hosts to the port such as user computers, servers, network printer...
Switch(vlan)#vlan 4 name vlan30 Switch(vlan)#exit Switch#configure t Enter configuration commands, one per line.End with CNTL/Z. Switch(config)#hostname sw1 sw1(config)#interface range fastEthernet 0/5 -9 sw1(config-if-range)#switchport mode access ...
通过了解接口封装类型和Trunk端口的关系,并采取相应的措施,我们可以成功解决“Command rejected: An interface whose trunk encapsulation is ‘Auto’ can not be configured as a trunk”这个错误。在配置Trunk端口时,确保将接口的封装类型设置为支持Trunk的配置方式,并正确配置接口为Trunk模式,这样就能够实现多个VLAN数...
What is the function of the command switchport trunk native vlan 999 on a Cisco Catalyst switch? A. It creates a VLAN 999 interface. B. It designates VLAN 999 for untagged traffic. C. It blocks VLAN 999 traffic from passing on the trunk. D. It designates VLAN 999 as the default for ...
This is a Cisco Switch port TRUNK sample configuration.Apply the following commands to Cisco Switch command line: interface GigabitEthernet1/1 description VMware ESX - Trunk A - NIC 0 – Port Description switchport trunk encapsulation dot1q –ESX only supports dot1q and not ISL switchport trunk...
两台Cisco2960交换机要设置为Trunk链接,正确命令是()。A.Switch#switchportmodetrunkB.Switch(config)#switch