discs (structures)fracturematerials testingmicrocrackspipessurface structuretransmission electron microscopyThis paper deals with microstructural studies carried out on an austenitic stainless steel rupture disc which was exposed to sodium–water reaction. The rupture disc was part of a leak simulator put in...
The company specializes in the production of various shapes of explosive discs for explosive dust industry - round, square, ellipse, trapezoidal, etc. It has the advantages of large size, good dynamic response to rapid pressure rise, no accumulation of materials, etc., and has been wid...
Type flat seat Material stainless steel Other characteristics low-pressure system Burst pressure Max.:500 mbar (7.25 psi) Min.:5 mbar (0.07 psi) Nominal diameter Max.:500 mm (20 in) Min.:50 mm (2 in) Catalogs Rupture discs and Explosion venting panels ...
The tensile strength of the construction material used for the manufacture of the discs is fairly high; therefore, forward-domed rupture discs for low pressures must be made of thin foils that make them vulnerable to mechanical damage during handling or installation. In reverse buckling discs, the...
The heat-resistant steel of the present invention has the characteristics such as creep rupture strength of at least 50 kg/mm2 at 450掳C for 105C hours and a 25掳 V-notch Charpy impact value of at least 5 kg-m/cm2 after heat treatment at 500掳C for 103 hours.Siga...
It has good resistance to corrosion and oxidation along with high tensile and creep-rupture properties at high temperatures to 1300F (700degree). This material has excellent relaxation resistance and is non-magnetic. It has good elevated temperature strength properties...
It has good resistance to corrosion and oxidation along with high tensile and creep-rupture properties at high temperatures to 1300F (700degree). This material has excellent relaxation resistance and is non-magnetic. It has good elevated temperature strength...
Compared to chromium-nickel austenitic stainless steels, 316L stainless steel offers higher creep, stress to rupture and tensile strength at elevated temperatures. Key Properties These properties are specified for the flat-rolled products (plate, sheet, and coil) in ASTM A240/A240M. Similar but not...
Type 316L stainless steel in a molybdenum bearing austenitic. It is more resistant to general corrosion and pitting than conventional nickel chromium stainless steels such as 302-304. It has the following characteristics:Higher creep resistance,Excellent formability,Rupture and tensile strength at high ...
The high C content steel can be made to have a limiting drawing ratio (ratio of the diameter of a disc-shaped steel material (blank) to the limiting inner diameter of the cup bottom at which a rupture takes place during drawing (LDR)) of at least 1.9 and a hardness (Hv) of at leas...