1: set ip next-hop {ip-address| recursive ip-address} , 如果一个route-map 中的同一个序列中 同时使用了 ip next-hop 跟ip next-hop recursive 时, 则ip next-hop 有效,同时一个route-map序列只允许配置一个 ip next-hop recursive 2: set ip next-hop verify-availability {next-hop-address sequ...
When the next hop address is specified on a directly-connected interface, the router does not perform ARP for each destination address. An example is IP route 0.0.0.0 0.0.0.0 Ethernet0 192.168.1.1. Only the directly connected next hop address is specified, but this is not recommended for the...
“The next-hop address is invalid”错误通常表示在配置路由或进行网络数据包转发时,指定的下一跳(next-hop)地址是不合法的或者不可达的。这可能是由于多种原因导致的,包括地址格式错误、地址不存在于网络上、接口未启用或配置错误等。 常见原因 地址错误:输入的下一跳地址格式不正确,如IPv4地址使用了IPv6的格式...
%Invalid next hop address (it's this router) 你这个地址已经配置在了本地路由器,你看看接口地址是不是配置了这个,这个报错就是这个意思哦! 2 有帮助 回复 suzhouxiaoniu Spotlight 发布时间 07-05-2016 05:45 PM 因为报错地址说地址在本地了,但是从配置和掩码设计来看,没有问题。建议把show ip...
neighbor {ip-address|peer-group-name} remote-as autonomous-system 改变下一跳属性 neighbor {ip-address|peer-group-name} next-hop-self 关闭BGP同步 no synchronization 在BGP表中创建一个归纳地址 aggregate-address ip-address mask [summary-only][as-set] ...
All devices have a gateway IP address set to 192.168.1.9 which is the IP address of the firewall. I would like to define multiple VLANs on the CISCO switch behind. Configuration targeted is : Vlan Id IP Network Name Additional info IP address Vlan 2 192.168.1.0/24 Data-VLAN...
Once in the configuration, static routes appear in the routing table if they are active.Active static routes have a valid next-hop option. Routes with reject or discard options as next hops always are active and present in the routing table. Routes with an IP address as a next hop are pr...
default是默认的意思，这句命令是用来设置默认路由的。意思是默认的路由下一跳地址是10.2.1.1。
(VRF) table is facilitated with the use of static routes. Either method provides the next-hop IP address (for multi-access segment) or points the route out of an interface (point-to-point interface). However, a static route cannot be used in the absence of a next-hop IP address on...
CISCO路由选择表进程每60S调用一个检查路由选择表的静态路由功能来根据动态变化的路由选择表安装或删除静态路由。 2.静态路由和中间地址 静态路由可以使用中间网络地址或出接口来创建。大多数情况下,使用出接口在路由选择表进程中解析静态路由更加有效。 只要中间IP地址可以在路由选择表中解析,它不必是真实的下一跳路由器...