1. Insert the ribbon cable back into the connector. 2. Install the broken clip back in place. 3. Secure the clip with sticky tape (or duct tape). sufi September 11, 2010| heya.. i hv dell inspiron 1545.. my lil’ bro has doodled on the front cover of my laptop with pen. so ...
To connect signals to the PXI-2530B via the TB-2630B, attach ribbon cable connectors (with corresponding ribbon cable) into the desired banks of ribbon cable headers. Ensure that the ribbon cables are properly reinforced by the strain relief bar, and then attach the terminal block cover. The...
Electronic devices including cameras and computers use ribbon cables. They come in a large variety of widths depending on the number of wires they contain, and a variety of lengths depending on their function. In computer systems, they are most often used to connect hard drives to a controller...
Now it’s time to reverse the process and install your replacement keyboard: Connect the new keyboard’s ribbon cable to the motherboard Ensure the connection is secure and the cable is not twisted Carefully place the new keyboard into position ...
Once that’s released, you should be able to gently pull the ribbon cable out of its socket. Repeat this process for any other ribbon cables attached to the bottom panel. Once they’re detached, you can set the bottom panel aside and gaze at the beautiful interior of your PC. Step ...
The switch was soldered into a small board that was connected to the main board with this ribbon. I removed the old switch but broke a few of the connections from the ribbon cable in the process. I have cleaned up the board and can just re-solder the whole lot, but need to strip ...
If you're opening an Ally X, be careful not to tear the ribbon cable that connects the motherboard to the back panel. Set the back panel aside. Next, you’ll want to disconnect the battery for safety. Lift up the black flap between the fans and, using a spudger, pry tool, ...
Ribbon cable connector from motherboard to hard-drive. I've unplugged the hard-drive to take the photo, but this is where it normally plugs in. Lithium-ion battery. This plugs into the bottom of the motherboard with a simple, standard, three-pin connector. ...
Next, flip the bottom cover over, and remove the hard drive's ATA ribbon cable from the connector on the motherboard. Once it's free, flip it back over and remove the four Torx screws holding the drive to the cover. Detach the ATA cable and inspect it for damage. Clean both the dri...
Reinsert it down into the socket from the top side. It should be flush when it is seated down into the socket: Gently push the ribbon cable straight down into the socket Push the side ribbon cable back into its connector: Reinsert the side ribbon cable into i...